arm: zynq: Enable distro defaults setting

[people/ms/u-boot.git] / configs / brppt1_mmc_defconfig

diff --git a/configs/brppt1_mmc_defconfig b/configs/brppt1_mmc_defconfig
index e2a009edd9d6c28e0ff6df1269c1eb695fcb8b0a..c41a7b439fe3c7106ea1c6d7b259bcb345b85c6d 100644 (file)
--- a/configs/brppt1_mmc_defconfig
+++ b/configs/brppt1_mmc_defconfig
@@ -7,6 +7,7 @@ CONFIG_AM33XX=y
 CONFIG_TARGET_BRPPT1=y
 CONFIG_SPL_MMC_SUPPORT=y
 CONFIG_SPL_SERIAL_SUPPORT=y
+# CONFIG_SPL_NAND_SUPPORT is not set
 CONFIG_SPL_WATCHDOG_SUPPORT=y
 CONFIG_OF_BOARD_SETUP=y
 CONFIG_SYS_EXTRA_OPTIONS="SERIAL1,CONS_INDEX=1,EMMC_BOOT"
@@ -26,18 +27,17 @@ CONFIG_SPL_YMODEM_SUPPORT=y
 CONFIG_HUSH_PARSER=y
 CONFIG_CMD_BOOTZ=y
 # CONFIG_CMD_IMI is not set
-# CONFIG_CMD_IMLS is not set
 # CONFIG_CMD_XIMG is not set
 # CONFIG_CMD_EDITENV is not set
 # CONFIG_CMD_CRC32 is not set
+# CONFIG_CMD_FLASH is not set
+# CONFIG_CMD_FPGA is not set
+CONFIG_CMD_GPIO=y
+CONFIG_CMD_I2C=y
 # CONFIG_CMD_LOADB is not set
 # CONFIG_CMD_LOADS is not set
-# CONFIG_CMD_FLASH is not set
 CONFIG_CMD_MMC=y
-CONFIG_CMD_I2C=y
 CONFIG_CMD_USB=y
-# CONFIG_CMD_FPGA is not set
-CONFIG_CMD_GPIO=y
 # CONFIG_CMD_ITEST is not set
 # CONFIG_CMD_SETEXPR is not set
 CONFIG_CMD_DHCP=y
@@ -48,8 +48,10 @@ CONFIG_CMD_EXT4=y
 CONFIG_CMD_EXT4_WRITE=y
 CONFIG_CMD_FAT=y
 CONFIG_CMD_FS_GENERIC=y
+CONFIG_ENV_IS_IN_MMC=y
 CONFIG_NETCONSOLE=y
 CONFIG_MMC_OMAP_HS=y
+CONFIG_PHYLIB=y
 CONFIG_SYS_NS16550=y
 CONFIG_USB=y
 CONFIG_USB_MUSB_HOST=y