arm: zynq: Enable distro defaults setting

[people/ms/u-boot.git] / configs / ls1021atwr_sdcard_qspi_defconfig

diff --git a/configs/ls1021atwr_sdcard_qspi_defconfig b/configs/ls1021atwr_sdcard_qspi_defconfig
index 0df54d86f47287206316da2cb045ddc06e0b3780..c91de279761d6683e6e6049a61de221709459c6e 100644 (file)
--- a/configs/ls1021atwr_sdcard_qspi_defconfig
+++ b/configs/ls1021atwr_sdcard_qspi_defconfig
@@ -5,7 +5,6 @@ CONFIG_SPL_LIBGENERIC_SUPPORT=y
 CONFIG_SPL_MMC_SUPPORT=y
 CONFIG_SPL_SERIAL_SUPPORT=y
 CONFIG_SPL_WATCHDOG_SUPPORT=y
-CONFIG_VIDEO=y
 CONFIG_DEFAULT_DEVICE_TREE="ls1021a-twr-duart"
 CONFIG_DISTRO_DEFAULTS=y
 CONFIG_FIT=y
@@ -14,7 +13,6 @@ CONFIG_OF_BOARD_SETUP=y
 CONFIG_OF_STDOUT_VIA_ALIAS=y
 CONFIG_SYS_EXTRA_OPTIONS="RAMBOOT_PBL,SPL_FSL_PBL,SD_BOOT,SD_BOOT_QSPI"
 CONFIG_SD_BOOT=y
-CONFIG_ENV_IS_IN_MMC=y
 CONFIG_BOOTDELAY=3
 CONFIG_USE_BOOTARGS=y
 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0"
@@ -27,7 +25,6 @@ CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xe8
 CONFIG_SPL_ENV_SUPPORT=y
 CONFIG_SPL_I2C_SUPPORT=y
 CONFIG_SPL_MPC8XXX_INIT_DDR_SUPPORT=y
-# CONFIG_CMD_IMLS is not set
 CONFIG_CMD_GREPENV=y
 CONFIG_CMD_MEMINFO=y
 CONFIG_CMD_MEMTEST=y
@@ -39,6 +36,7 @@ CONFIG_CMD_USB=y
 CONFIG_CMD_BMP=y
 # CONFIG_SPL_EFI_PARTITION is not set
 CONFIG_OF_CONTROL=y
+CONFIG_ENV_IS_IN_MMC=y
 CONFIG_DM=y
 CONFIG_FSL_CAAM=y
 CONFIG_SPI_FLASH=y
@@ -62,4 +60,5 @@ CONFIG_USB_XHCI_HCD=y
 CONFIG_USB_XHCI_DWC3=y
 CONFIG_USB_STORAGE=y
 CONFIG_VIDEO_FSL_DCU_FB=y
+CONFIG_VIDEO=y
 # CONFIG_VIDEO_SW_CURSOR is not set