arm: zynq: Enable distro defaults setting

[people/ms/u-boot.git] / configs / tec-ng_defconfig

diff --git a/configs/tec-ng_defconfig b/configs/tec-ng_defconfig
index b7102298e375050aa6ff167b0e508f5845babdbe..f785757a5d2a8f89e16f99e31957d91600ce1b76 100644 (file)
--- a/configs/tec-ng_defconfig
+++ b/configs/tec-ng_defconfig
@@ -1,38 +1,36 @@
 CONFIG_ARM=y
 CONFIG_TEGRA=y
-CONFIG_SPL_DM=y
 CONFIG_TEGRA30=y
 CONFIG_TARGET_TEC_NG=y
 CONFIG_DEFAULT_DEVICE_TREE="tegra30-tec-ng"
 CONFIG_FIT=y
 CONFIG_OF_SYSTEM_SETUP=y
-CONFIG_HUSH_PARSER=y
+CONFIG_CONSOLE_MUX=y
+CONFIG_SYS_STDIO_DEREGISTER=y
 CONFIG_SYS_PROMPT="Tegra30 (TEC-NG) # "
-CONFIG_CMD_BOOTZ=y
 # CONFIG_CMD_IMI is not set
-# CONFIG_CMD_IMLS is not set
 # CONFIG_CMD_FLASH is not set
+# CONFIG_CMD_FPGA is not set
+CONFIG_CMD_GPIO=y
+CONFIG_CMD_I2C=y
 CONFIG_CMD_MMC=y
 CONFIG_CMD_SF=y
 CONFIG_CMD_SPI=y
-CONFIG_CMD_I2C=y
 CONFIG_CMD_USB=y
-# CONFIG_CMD_FPGA is not set
-CONFIG_CMD_GPIO=y
 # CONFIG_CMD_SETEXPR is not set
-CONFIG_CMD_DHCP=y
 # CONFIG_CMD_NFS is not set
-CONFIG_CMD_MII=y
-CONFIG_CMD_PING=y
-CONFIG_CMD_EXT2=y
-CONFIG_CMD_EXT4=y
 CONFIG_CMD_EXT4_WRITE=y
-CONFIG_CMD_FAT=y
-CONFIG_CMD_FS_GENERIC=y
+# CONFIG_SPL_DOS_PARTITION is not set
+# CONFIG_SPL_ISO_PARTITION is not set
+# CONFIG_SPL_EFI_PARTITION is not set
+CONFIG_SPL_DM=y
 CONFIG_SPI_FLASH=y
 CONFIG_SPI_FLASH_WINBOND=y
 CONFIG_SYS_NS16550=y
 CONFIG_TEGRA20_SLINK=y
 CONFIG_USB=y
 CONFIG_DM_USB=y
-CONFIG_USE_PRIVATE_LIBGCC=y
+CONFIG_USB_EHCI_HCD=y
+CONFIG_USB_STORAGE=y
+CONFIG_USB_HOST_ETHER=y
+CONFIG_USB_ETHER_SMSC95XX=y