Migrate generic bootcount to Kconfig
[people/ms/u-boot.git] / drivers / bootcount / Kconfig
index eabfd13..9fde2f2 100644 (file)
@@ -13,6 +13,17 @@ if BOOTCOUNT_LIMIT
 choice
        prompt "Boot count device"
        default BOOTCOUNT_AM33XX if AM33XX || SOC_DA8XX
+       default BOOTCOUNT_AT91 if AT91SAM9XE
+       default BOOTCOUNT_GENERIC
+
+config BOOTCOUNT_GENERIC
+       bool "Generic default boot counter"
+       help
+         Generic bootcount stored at SYS_BOOTCOUNT_ADDR.
+
+         SYS_BOOTCOUNT_ADDR:
+           Set to the address where the bootcount and bootcount magic
+           will be stored.
 
 config BOOTCOUNT_EXT
        bool "Boot counter on EXT filesystem"
@@ -46,10 +57,24 @@ config BOOTCOUNT_RAM
          Store the bootcount in DRAM protected against against bit errors
          due to short power loss or holding a system in RESET.
 
+config BOOTCOUNT_I2C
+       bool "Boot counter on I2C device"
+       help
+         Enable support for the bootcounter on an i2c (like RTC) device.
+         CONFIG_SYS_I2C_RTC_ADDR = i2c chip address
+         CONFIG_SYS_BOOTCOUNT_ADDR = i2c addr which is used for
+                                     the bootcounter.
+         CONFIG_BOOTCOUNT_ALEN = address len
+
+config BOOTCOUNT_AT91
+       bool "Boot counter for Atmel AT91SAM9XE"
+       depends on AT91SAM9XE
+
 endchoice
 
 config SYS_BOOTCOUNT_SINGLEWORD
        bool "Use single word to pack boot count and magic value"
+       depends on BOOTCOUNT_GENERIC
        help
          This option enables packing boot count magic value and boot count
          into single word (32 bits).