#ifdef CONFIG_SOC_DA8XX
#include <asm/arch/hardware.h>
#endif
+#ifdef CONFIG_FSL_LSCH3
+#include <asm/arch/immap_lsch3.h>
+#endif
+#ifdef CONFIG_FSL_LSCH2
+#include <asm/arch/immap_lsch2.h>
+#endif
#include <part.h>
#include <flash.h>
#define BUG_ON(condition) do { if (unlikely((condition)!=0)) BUG(); } while(0)
#endif /* BUG */
-/* Force a compilation error if condition is true */
-#define BUILD_BUG_ON(condition) ((void)sizeof(char[1 - 2*!!(condition)]))
-
typedef void (interrupt_handler_t)(void *);
#include <asm/u-boot.h> /* boot information for Linux kernel */
* @return 0 on success, or != 0 on error.
*/
int run_command_list(const char *cmd, int len, int flag);
-extern char console_buffer[];
/* arch/$(ARCH)/lib/board.c */
void board_init_f(ulong);
void board_init_r(gd_t *, ulong) __attribute__ ((noreturn));
/**
- * board_init_f_mem() - Allocate global data and set stack position
+ * ulong board_init_f_alloc_reserve - allocate reserved area
*
* This function is called by each architecture very early in the start-up
- * code to set up the environment for board_init_f(). It allocates space for
- * global_data (see include/asm-generic/global_data.h) and places the stack
- * below this.
+ * code to allow the C runtime to reserve space on the stack for writable
+ * 'globals' such as GD and the malloc arena.
*
- * This function requires a stack[1] Normally this is at @top. The function
- * starts allocating space from 64 bytes below @top. First it creates space
- * for global_data. Then it calls arch_setup_gd() which sets gd to point to
- * the global_data space and can reserve additional bytes of space if
- * required). Finally it allocates early malloc() memory
- * (CONFIG_SYS_MALLOC_F_LEN). The new top of the stack is just below this,
- * and it returned by this function.
+ * @top: top of the reserve area, growing down.
+ * @return: bottom of reserved area
+ */
+ulong board_init_f_alloc_reserve(ulong top);
+
+/**
+ * board_init_f_init_reserve - initialize the reserved area(s)
*
- * [1] Strictly speaking it would be possible to implement this function
- * in C on many archs such that it does not require a stack. However this
- * does not seem hugely important as only 64 byte are wasted. The 64 bytes
- * are used to handle the calling standard which generally requires pushing
- * addresses or registers onto the stack. We should be able to get away with
- * less if this becomes important.
+ * This function is called once the C runtime has allocated the reserved
+ * area on the stack. It must initialize the GD at the base of that area.
*
- * @top: Top of available memory, also normally the top of the stack
- * @return: New stack location
+ * @base: top from which reservation was done
*/
-ulong board_init_f_mem(ulong top);
+void board_init_f_init_reserve(ulong base);
/**
* arch_setup_gd() - Set up the global_data pointer
void pci_init (void);
void pci_init_board(void);
-void pciinfo (int, int);
#if defined(CONFIG_PCI) && defined(CONFIG_4xx)
int pci_pre_init (struct pci_controller *);
void fdc_hw_init (void);
/* $(BOARD)/eeprom.c */
-void eeprom_init (void);
-#ifndef CONFIG_SPI
-int eeprom_probe (unsigned dev_addr, unsigned offset);
-#endif
+void eeprom_init (int bus);
int eeprom_read (unsigned dev_addr, unsigned offset, uchar *buffer, unsigned cnt);
int eeprom_write (unsigned dev_addr, unsigned offset, uchar *buffer, unsigned cnt);
ulong get_tbclk (void);
void reset_misc (void);
void reset_cpu (ulong addr);
-#if defined (CONFIG_OF_LIBFDT) && defined (CONFIG_OF_BOARD_SETUP)
void ft_cpu_setup(void *blob, bd_t *bd);
-#ifdef CONFIG_PCI
void ft_pci_setup(void *blob, bd_t *bd);
-#endif
-#endif
void smp_set_core_boot_addr(unsigned long addr, int corenr);
void smp_kick_all_cpus(void);
#if defined(CONFIG_MPC85xx)
typedef MPC85xx_SYS_INFO sys_info_t;
void get_sys_info ( sys_info_t * );
-# if defined(CONFIG_OF_LIBFDT)
- void ft_fixup_cpu(void *, u64);
- void ft_fixup_num_cores(void *);
-# endif
+void ft_fixup_cpu(void *, u64);
+void ft_fixup_num_cores(void *);
#endif
#if defined(CONFIG_MPC86xx)
typedef MPC86xx_SYS_INFO sys_info_t;
* for files under 4GiB
*/
int gzwrite(unsigned char *src, int len,
- struct block_dev_desc *dev,
+ struct blk_desc *dev,
unsigned long szwritebuf,
u64 startoffs,
u64 szexpected);
+/* lib/lz4_wrapper.c */
+int ulz4fn(const void *src, size_t srcn, void *dst, size_t *dstn);
+
/* lib/qsort.c */
void qsort(void *base, size_t nmemb, size_t size,
int(*compar)(const void *, const void *));
unsigned int rand(void);
unsigned int rand_r(unsigned int *seedp);
-/* common/console.c */
-int console_init_f(void); /* Before relocation; uses the serial stuff */
-int console_init_r(void); /* After relocation; uses the console stuff */
-int console_assign(int file, const char *devname); /* Assign the console */
-int ctrlc (void);
-int had_ctrlc (void); /* have we had a Control-C since last clear? */
-void clear_ctrlc (void); /* clear the Control-C condition */
-int disable_ctrlc (int); /* 1 to disable, 0 to enable Control-C detect */
-int confirm_yesno(void); /* 1 if input is "y", "Y", "yes" or "YES" */
/*
* STDIO based functions (can always be used)
*/
return string_to_ip(getenv(var));
}
-/*
- * CONSOLE multiplexing.
- */
-#ifdef CONFIG_CONSOLE_MUX
-#include <iomux.h>
-#endif
-
int pcmcia_init (void);
#ifdef CONFIG_STATUS_LED
projects / people / ms / u-boot.git / blobdiff