Convert CONFIG_BOOTP_BOOTPATH et al to Kconfig

[people/ms/u-boot.git] / include / configs / BSC9131RDB.h

diff --git a/include/configs/BSC9131RDB.h b/include/configs/BSC9131RDB.h
index 81021ba5a33e552668e54d5ba0937b90d9150ea7..56e6e149d5f18c70471f095e49745bac454e1c6d 100644 (file)
--- a/include/configs/BSC9131RDB.h
+++ b/include/configs/BSC9131RDB.h
@@ -11,16 +11,12 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
-#ifdef CONFIG_BSC9131RDB
-#define CONFIG_BSC9131
 #define CONFIG_NAND_FSL_IFC
-#endif
 
 #ifdef CONFIG_SPIFLASH
 #define CONFIG_RAMBOOT_SPIFLASH
 #define CONFIG_SYS_RAMBOOT
 #define CONFIG_SYS_EXTRA_ENV_RELOC
-#define CONFIG_SYS_TEXT_BASE           0x11000000
 #define CONFIG_RESET_VECTOR_ADDRESS    0x110bfffc
 #endif
 
@@ -30,7 +26,6 @@
 #define CONFIG_SPL_FLUSH_IMAGE
 #define CONFIG_SPL_TARGET              "u-boot-with-spl.bin"
 
-#define CONFIG_SYS_TEXT_BASE           0x00201000
 #define CONFIG_SPL_TEXT_BASE           0xFFFFE000
 #define CONFIG_SPL_MAX_SIZE            8192
 #define CONFIG_SPL_RELOC_TEXT_BASE     0x00100000
@@ -49,12 +44,7 @@
 #endif
 
 /* High Level Configuration Options */
-#define CONFIG_BOOKE                   /* BOOKE */
-#define CONFIG_E500                    /* BOOKE e500 family */
-#define CONFIG_FSL_IFC                 /* Enable IFC Support */
-#define CONFIG_FSL_CAAM                        /* Enable SEC/CAAM */
 
-#define CONFIG_FSL_LAW                 /* Use common FSL init code */
 #define CONFIG_TSEC_ENET
 #define CONFIG_ENV_OVERWRITE
 
@@ -76,7 +66,6 @@
 #define CONFIG_SYS_MEMTEST_END         0x01ffffff
 
 /* DDR Setup */
-#define CONFIG_SYS_FSL_DDR3
 #undef CONFIG_SYS_DDR_RAW_TIMING
 #undef CONFIG_DDR_SPD
 #define CONFIG_SYS_SPD_BUS_NUM         0
@@ -91,7 +80,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_DDR_SDRAM_BASE      0x00000000
 #define CONFIG_SYS_SDRAM_BASE          CONFIG_SYS_DDR_SDRAM_BASE
 
-#define CONFIG_NUM_DDR_CONTROLLERS     1
 #define CONFIG_DIMM_SLOTS_PER_CTLR     1
 #define CONFIG_CHIP_SELECTS_PER_CTRL   1
 
@@ -156,7 +144,6 @@ extern unsigned long get_sdram_size(void);
 /*
  * IFC Definitions
  */
-#define CONFIG_SYS_NO_FLASH
 
 /* NAND Flash on IFC */
 #define CONFIG_SYS_NAND_BASE           0xff800000
@@ -192,7 +179,6 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_SYS_NAND_BASE_LIST      { CONFIG_SYS_NAND_BASE }
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
-#define CONFIG_CMD_NAND
 #define CONFIG_SYS_NAND_BLOCK_SIZE     (128 * 1024)
 
 #define CONFIG_SYS_NAND_DDR_LAW                11
@@ -206,8 +192,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_CS0_FTIM2           CONFIG_SYS_NAND_FTIM2
 #define CONFIG_SYS_CS0_FTIM3           CONFIG_SYS_NAND_FTIM3
 
-#define CONFIG_BOARD_EARLY_INIT_F      /* Call board_pre_init */
-
 #define CONFIG_SYS_INIT_RAM_LOCK
 #define CONFIG_SYS_INIT_RAM_ADDR       0xffd00000      /* stack in RAM */
 #define CONFIG_SYS_INIT_RAM_SIZE       0x00004000/* End of used area in RAM */
@@ -229,8 +213,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_NS16550_MIN_FUNCTIONS
 #endif
 
-#define CONFIG_SYS_CONSOLE_IS_IN_ENV   /* determine from environment */
-
 #define CONFIG_SYS_BAUDRATE_TABLE      \
        {300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200}
 
@@ -243,7 +225,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_FSL_I2C_OFFSET      0x3000
 
 /* I2C EEPROM */
-#define CONFIG_CMD_EEPROM
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -275,15 +256,12 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_ETHPRIME                "eTSEC1"
 
-#define CONFIG_PHY_GIGE                /* Include GbE speed/duplex detection */
-
 #endif /* CONFIG_TSEC_ENET */
 
 /*
  * Environment
  */
 #if defined(CONFIG_RAMBOOT_SPIFLASH)
-#define CONFIG_ENV_IS_IN_SPI_FLASH
 #define CONFIG_ENV_SPI_BUS     0
 #define CONFIG_ENV_SPI_CS      0
 #define CONFIG_ENV_SPI_MAX_HZ  10000000
@@ -292,13 +270,11 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_ENV_SECT_SIZE   0x10000
 #define CONFIG_ENV_SIZE                0x2000
 #elif defined(CONFIG_NAND)
-#define CONFIG_ENV_IS_IN_NAND
 #define CONFIG_SYS_EXTRA_ENV_RELOC
 #define CONFIG_ENV_SIZE                CONFIG_SYS_NAND_BLOCK_SIZE
 #define CONFIG_ENV_OFFSET      ((768 * 1024) + CONFIG_SYS_NAND_BLOCK_SIZE)
 #define CONFIG_ENV_RANGE       (3 * CONFIG_ENV_SIZE)
 #elif defined(CONFIG_SYS_RAMBOOT)
-#define CONFIG_ENV_IS_NOWHERE  /* Store ENV in memory only */
 #define CONFIG_ENV_ADDR                (CONFIG_SYS_MONITOR_BASE - 0x1000)
 #define CONFIG_ENV_SIZE                0x2000
 #endif
@@ -306,20 +282,9 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_LOADS_ECHO              /* echo on for serial download */
 #define CONFIG_SYS_LOADS_BAUD_CHANGE           /* allow baudrate change */
 
-/*
- * Command line configuration.
- */
-#define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_IRQ
-#define CONFIG_DOS_PARTITION
-#define CONFIG_CMD_REGINFO
-
 /*
  * Miscellaneous configurable options
  */
-#define CONFIG_SYS_LONGHELP                    /* undef to save memory */
-#define CONFIG_CMDLINE_EDITING                 /* Command-line editing */
-#define CONFIG_AUTO_COMPLETE                   /* add autocompletion support */
 #define CONFIG_SYS_LOAD_ADDR   0x2000000       /* default load address */
 
 #if defined(CONFIG_CMD_KGDB)
@@ -327,9 +292,6 @@ extern unsigned long get_sdram_size(void);
 #else
 #define CONFIG_SYS_CBSIZE      1024            /* Console I/O Buffer Size */
 #endif
-#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16)
-                                               /* Print Buffer Size */
-#define CONFIG_SYS_MAXARGS     16              /* max number of command args */
 #define CONFIG_SYS_BARGSIZE    CONFIG_SYS_CBSIZE/* Boot Argument Buffer Size */
 
 /*
@@ -344,15 +306,7 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_KGDB_BAUDRATE   230400  /* speed to run kgdb serial port */
 #endif
 
-/* Hash command with SHA acceleration supported in hardware */
-#ifdef CONFIG_FSL_CAAM
-#define CONFIG_CMD_HASH
-#define CONFIG_SHA_HW_ACCEL
-#endif
-
-#define CONFIG_USB_EHCI
-
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #define CONFIG_HAS_FSL_DR_USB
@@ -363,17 +317,6 @@ extern unsigned long get_sdram_size(void);
  */
 #define CONFIG_MTD_DEVICE
 #define CONFIG_MTD_PARTITIONS
-#define CONFIG_CMD_MTDPARTS
-#define MTDIDS_DEFAULT "nand0=ff800000.flash,"
-#define MTDPARTS_DEFAULT "mtdparts=ff800000.flash:1m(uboot)," \
-                       "8m(kernel),512k(dtb),-(fs)"
-/*
- * Override partitions in device tree using info
- * in "mtdparts" environment variable
- */
-#ifdef CONFIG_CMD_MTDPARTS
-#define CONFIG_FDT_FIXUP_PARTITIONS
-#endif
 
 /*
  * Environment Configuration
@@ -388,8 +331,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_BOOTFILE                "uImage"
 #define CONFIG_UBOOTPATH       "u-boot.bin" /* U-Boot image on TFTP server */
 
-#define CONFIG_BAUDRATE                115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
        "netdev=eth0\0"                                         \
        "uboot=" CONFIG_UBOOTPATH "\0"                          \