Convert CONFIG_CMD_EEPROM et al to Kconfig

[people/ms/u-boot.git] / include / configs / BSC9131RDB.h

diff --git a/include/configs/BSC9131RDB.h b/include/configs/BSC9131RDB.h
index 86419eb8f3d65fe8e87183c516897835f6400102..87aec6a7aa06c30d2a9d913538bdea97f380d50d 100644 (file)
--- a/include/configs/BSC9131RDB.h
+++ b/include/configs/BSC9131RDB.h
@@ -11,10 +11,7 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
-#ifdef CONFIG_BSC9131RDB
-#define CONFIG_BSC9131
 #define CONFIG_NAND_FSL_IFC
-#endif
 
 #ifdef CONFIG_SPIFLASH
 #define CONFIG_RAMBOOT_SPIFLASH
@@ -49,12 +46,7 @@
 #endif
 
 /* High Level Configuration Options */
-#define CONFIG_BOOKE                   /* BOOKE */
-#define CONFIG_E500                    /* BOOKE e500 family */
-#define CONFIG_FSL_IFC                 /* Enable IFC Support */
-#define CONFIG_FSL_CAAM                        /* Enable SEC/CAAM */
 
-#define CONFIG_FSL_LAW                 /* Use common FSL init code */
 #define CONFIG_TSEC_ENET
 #define CONFIG_ENV_OVERWRITE
 
@@ -76,7 +68,6 @@
 #define CONFIG_SYS_MEMTEST_END         0x01ffffff
 
 /* DDR Setup */
-#define CONFIG_SYS_FSL_DDR3
 #undef CONFIG_SYS_DDR_RAW_TIMING
 #undef CONFIG_DDR_SPD
 #define CONFIG_SYS_SPD_BUS_NUM         0
@@ -91,7 +82,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_DDR_SDRAM_BASE      0x00000000
 #define CONFIG_SYS_SDRAM_BASE          CONFIG_SYS_DDR_SDRAM_BASE
 
-#define CONFIG_NUM_DDR_CONTROLLERS     1
 #define CONFIG_DIMM_SLOTS_PER_CTLR     1
 #define CONFIG_CHIP_SELECTS_PER_CTRL   1
 
@@ -156,7 +146,6 @@ extern unsigned long get_sdram_size(void);
 /*
  * IFC Definitions
  */
-#define CONFIG_SYS_NO_FLASH
 
 /* NAND Flash on IFC */
 #define CONFIG_SYS_NAND_BASE           0xff800000
@@ -206,8 +195,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_CS0_FTIM2           CONFIG_SYS_NAND_FTIM2
 #define CONFIG_SYS_CS0_FTIM3           CONFIG_SYS_NAND_FTIM3
 
-#define CONFIG_BOARD_EARLY_INIT_F      /* Call board_pre_init */
-
 #define CONFIG_SYS_INIT_RAM_LOCK
 #define CONFIG_SYS_INIT_RAM_ADDR       0xffd00000      /* stack in RAM */
 #define CONFIG_SYS_INIT_RAM_SIZE       0x00004000/* End of used area in RAM */
@@ -241,7 +228,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_FSL_I2C_OFFSET      0x3000
 
 /* I2C EEPROM */
-#define CONFIG_CMD_EEPROM
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -309,7 +295,6 @@ extern unsigned long get_sdram_size(void);
  */
 #define CONFIG_CMD_ERRATA
 #define CONFIG_CMD_IRQ
-#define CONFIG_DOS_PARTITION
 #define CONFIG_CMD_REGINFO
 
 /*
@@ -345,12 +330,9 @@ extern unsigned long get_sdram_size(void);
 /* Hash command with SHA acceleration supported in hardware */
 #ifdef CONFIG_FSL_CAAM
 #define CONFIG_CMD_HASH
-#define CONFIG_SHA_HW_ACCEL
 #endif
 
-#define CONFIG_USB_EHCI
-
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #define CONFIG_HAS_FSL_DR_USB
@@ -379,8 +361,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_BOOTFILE                "uImage"
 #define CONFIG_UBOOTPATH       "u-boot.bin" /* U-Boot image on TFTP server */
 
-#define CONFIG_BAUDRATE                115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
        "netdev=eth0\0"                                         \
        "uboot=" CONFIG_UBOOTPATH "\0"                          \