configs: Re-sync HUSH options

[people/ms/u-boot.git] / include / configs / BSC9131RDB.h

diff --git a/include/configs/BSC9131RDB.h b/include/configs/BSC9131RDB.h
index adb81461dd62b5267120756ca79186d628812774..e7a90bdaaac03ec238f5c5596e55a5b4cca49a48 100644 (file)
--- a/include/configs/BSC9131RDB.h
+++ b/include/configs/BSC9131RDB.h
@@ -11,6 +11,8 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
+#define CONFIG_DISPLAY_BOARDINFO
+
 #ifdef CONFIG_BSC9131RDB
 #define CONFIG_BSC9131
 #define CONFIG_NAND_FSL_IFC
@@ -195,7 +197,6 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_SYS_NAND_BASE_LIST      { CONFIG_SYS_NAND_BASE }
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
-#define CONFIG_MTD_NAND_VERIFY_WRITE
 #define CONFIG_CMD_NAND
 #define CONFIG_SYS_NAND_BLOCK_SIZE     (128 * 1024)
 
@@ -214,9 +215,9 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_SYS_INIT_RAM_LOCK
 #define CONFIG_SYS_INIT_RAM_ADDR       0xffd00000      /* stack in RAM */
-#define CONFIG_SYS_INIT_RAM_END                0x00004000/* End of used area in RAM */
+#define CONFIG_SYS_INIT_RAM_SIZE       0x00004000/* End of used area in RAM */
 
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END \
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE \
                                                - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      CONFIG_SYS_GBL_DATA_OFFSET
 
@@ -226,7 +227,6 @@ extern unsigned long get_sdram_size(void);
 /* Serial Port */
 #define CONFIG_CONS_INDEX      1
 #undef CONFIG_SERIAL_SOFTWARE_FIFO
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE    1
 #define CONFIG_SYS_NS16550_CLK         get_bus_freq(0)
@@ -241,23 +241,6 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_SYS_NS16550_COM1        (CONFIG_SYS_CCSRBAR+0x4500)
 
-/* Use the HUSH parser */
-#define CONFIG_SYS_HUSH_PARSER
-#ifdef CONFIG_SYS_HUSH_PARSER
-#define CONFIG_SYS_PROMPT_HUSH_PS2 "> "
-#endif
-
-/*
- * Pass open firmware flat tree
- */
-#define CONFIG_OF_LIBFDT
-#define CONFIG_OF_BOARD_SETUP
-#define CONFIG_OF_STDOUT_VIA_ALIAS
-
-/* new uImage format support */
-#define CONFIG_FIT
-#define CONFIG_FIT_VERBOSE     /* enable fit_format_{error,warning}() */
-
 #define CONFIG_SYS_I2C
 #define CONFIG_SYS_I2C_FSL
 #define CONFIG_SYS_FSL_I2C_SPEED       400000
@@ -266,7 +249,6 @@ extern unsigned long get_sdram_size(void);
 
 /* I2C EEPROM */
 #define CONFIG_CMD_EEPROM
-#define CONFIG_SYS_I2C_MULTI_EEPROMS
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -274,11 +256,8 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_CMD_I2C
 
 
-#define CONFIG_FSL_ESPI
 /* eSPI - Enhanced SPI */
 #ifdef CONFIG_FSL_ESPI
-#define CONFIG_SPI_FLASH
-#define CONFIG_SPI_FLASH_SPANSION
 #define CONFIG_CMD_SF
 #define CONFIG_SF_DEFAULT_SPEED                10000000
 #define CONFIG_SF_DEFAULT_MODE         SPI_MODE_0
@@ -339,11 +318,8 @@ extern unsigned long get_sdram_size(void);
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
 #define CONFIG_CMD_DHCP
 #define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_EXT2
 #define CONFIG_CMD_FAT
 #define CONFIG_CMD_IRQ
@@ -351,7 +327,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_DOS_PARTITION
 #define CONFIG_CMD_PING
 #define CONFIG_CMD_REGINFO
-#define CONFIG_CMD_SETEXPR
 
 /*
  * Miscellaneous configurable options
@@ -430,6 +405,7 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_UBOOTPATH       "u-boot.bin" /* U-Boot image on TFTP server */
 
 #define CONFIG_BAUDRATE                115200
+#define CONFIG_BOOTDELAY       10 /* -1 disable auto-boot */
 
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
        "netdev=eth0\0"                                         \