Kconfig: Migrate CONFIG_BAUDRATE

[people/ms/u-boot.git] / include / configs / MPC8540ADS.h

diff --git a/include/configs/MPC8540ADS.h b/include/configs/MPC8540ADS.h
index 37c2b9415af9fb040d1c1f7410d97b688c7c40a7..c5d581589aa1dba0d8921e739719d2b9c99beefe 100644 (file)
--- a/include/configs/MPC8540ADS.h
+++ b/include/configs/MPC8540ADS.h
@@ -12,18 +12,12 @@
  * Please refer to doc/README.mpc85xx for more info.
  *
  * Make sure you change the MAC address and other network params first,
- * search for CONFIG_ETHADDR, CONFIG_SERVERIP, etc in this file.
+ * search for CONFIG_SERVERIP, etc in this file.
  */
 
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
-/* High Level Configuration Options */
-#define CONFIG_BOOKE           1       /* BOOKE */
-#define CONFIG_E500            1       /* BOOKE e500 family */
-#define CONFIG_MPC8540         1       /* MPC8540 specific */
-#define CONFIG_MPC8540ADS      1       /* MPC8540ADS board specific */
-
 /*
  * default CCARBAR is at 0xff700000
  * assume U-Boot is less than 0.5MB
@@ -34,12 +28,10 @@
 #define CONFIG_HAS_FEC         1       /* 8540 has FEC */
 #endif
 
-#define CONFIG_PCI
 #define CONFIG_PCI_INDIRECT_BRIDGE
 #define CONFIG_SYS_PCI_64BIT   1       /* enable 64-bit PCI resources */
 #define CONFIG_TSEC_ENET               /* tsec ethernet support */
 #define CONFIG_ENV_OVERWRITE
-#define CONFIG_FSL_LAW         1       /* Use common FSL init code */
 
 /*
  * sysclk for MPC85xx
@@ -63,7 +55,6 @@
 #define CONFIG_SYS_CLK_FREQ    33000000
 #endif
 
-
 /*
  * These can be toggled for performance analysis, otherwise use default.
  */
@@ -77,7 +68,6 @@
 #define CONFIG_SYS_CCSRBAR_PHYS_LOW    CONFIG_SYS_CCSRBAR
 
 /* DDR Setup */
-#define CONFIG_SYS_FSL_DDR1
 #define CONFIG_SPD_EEPROM              /* Use SPD EEPROM for DDR setup*/
 #define CONFIG_DDR_SPD
 #undef CONFIG_FSL_DDR_INTERACTIVE
@@ -87,7 +77,6 @@
 #define CONFIG_SYS_DDR_SDRAM_BASE      0x00000000      /* DDR is system memory*/
 #define CONFIG_SYS_SDRAM_BASE          CONFIG_SYS_DDR_SDRAM_BASE
 
-#define CONFIG_NUM_DDR_CONTROLLERS     1
 #define CONFIG_DIMM_SLOTS_PER_CTLR     1
 #define CONFIG_CHIP_SELECTS_PER_CTRL   (2 * CONFIG_DIMM_SLOTS_PER_CTLR)
 
@@ -134,7 +123,6 @@
 
 #undef CONFIG_CLOCKS_IN_MHZ
 
-
 /*
  * Local Bus Definitions
  */
@@ -199,7 +187,6 @@
 #define CONFIG_SYS_LBC_LSDMR_4 (CONFIG_SYS_LBC_LSDMR_COMMON | LSDMR_OP_MRW)
 #define CONFIG_SYS_LBC_LSDMR_5 (CONFIG_SYS_LBC_LSDMR_COMMON | LSDMR_OP_NORMAL)
 
-
 /*
  * 32KB, 8-bit wide for ADS config reg
  */
@@ -219,7 +206,6 @@
 
 /* Serial Port */
 #define CONFIG_CONS_INDEX     1
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE    1
 #define CONFIG_SYS_NS16550_CLK         get_bus_freq(0)
@@ -230,16 +216,6 @@
 #define CONFIG_SYS_NS16550_COM1        (CONFIG_SYS_CCSRBAR+0x4500)
 #define CONFIG_SYS_NS16550_COM2        (CONFIG_SYS_CCSRBAR+0x4600)
 
-/* Use the HUSH parser */
-#define CONFIG_SYS_HUSH_PARSER
-#ifdef  CONFIG_SYS_HUSH_PARSER
-#endif
-
-/* pass open firmware flat tree */
-#define CONFIG_OF_LIBFDT               1
-#define CONFIG_OF_BOARD_SETUP          1
-#define CONFIG_OF_STDOUT_VIA_ALIAS     1
-
 /*
  * I2C
  */
@@ -270,9 +246,6 @@
 #define CONFIG_SYS_PCI1_IO_SIZE        0x100000        /* 1M */
 
 #if defined(CONFIG_PCI)
-
-#define CONFIG_PCI_PNP                 /* do pci plug-and-play */
-
 #undef CONFIG_EEPRO100
 #undef CONFIG_TULIP
 
@@ -287,7 +260,6 @@
 
 #endif /* CONFIG_PCI */
 
-
 #if defined(CONFIG_TSEC_ENET)
 
 #define CONFIG_MII             1       /* MII PHY management */
@@ -302,7 +274,6 @@
 #define TSEC1_FLAGS            TSEC_GIGABIT
 #define TSEC2_FLAGS            TSEC_GIGABIT
 
-
 #if CONFIG_HAS_FEC
 #define CONFIG_MPC85XX_FEC     1
 #define CONFIG_MPC85XX_FEC_NAME                "FEC"
@@ -316,7 +287,6 @@
 
 #endif /* CONFIG_TSEC_ENET */
 
-
 /*
  * Environment
  */
@@ -326,7 +296,6 @@
   #define CONFIG_ENV_SECT_SIZE 0x40000 /* 256K(one sector) for env */
   #define CONFIG_ENV_SIZE              0x2000
 #else
-  #define CONFIG_SYS_NO_FLASH          1       /* Flash is not usable now */
   #define CONFIG_ENV_IS_NOWHERE        1       /* Store ENV in memory only */
   #define CONFIG_ENV_ADDR              (CONFIG_SYS_MONITOR_BASE - 0x1000)
   #define CONFIG_ENV_SIZE              0x2000
@@ -335,7 +304,6 @@
 #define CONFIG_LOADS_ECHO      1       /* echo on for serial download */
 #define CONFIG_SYS_LOADS_BAUD_CHANGE   1       /* allow baudrate change */
 
-
 /*
  * BOOTP options
  */
@@ -344,28 +312,15 @@
 #define CONFIG_BOOTP_GATEWAY
 #define CONFIG_BOOTP_HOSTNAME
 
-
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
-#define CONFIG_CMD_PING
-#define CONFIG_CMD_I2C
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_IRQ
-#define CONFIG_CMD_SETEXPR
 
 #if defined(CONFIG_PCI)
     #define CONFIG_CMD_PCI
 #endif
 
-#if defined(CONFIG_SYS_RAMBOOT)
-    #undef CONFIG_CMD_SAVEENV
-    #undef CONFIG_CMD_LOADS
-#endif
-
-
 #undef CONFIG_WATCHDOG                 /* watchdog disabled */
 
 /*
@@ -398,7 +353,6 @@
 #define CONFIG_KGDB_BAUDRATE   230400  /* speed to run kgdb serial port */
 #endif
 
-
 /*
  * Environment Configuration
  */
@@ -406,11 +360,8 @@
 /* The mac addresses for all ethernet interface */
 #if defined(CONFIG_TSEC_ENET)
 #define CONFIG_HAS_ETH0
-#define CONFIG_ETHADDR   00:E0:0C:00:00:FD
 #define CONFIG_HAS_ETH1
-#define CONFIG_ETH1ADDR  00:E0:0C:00:01:FD
 #define CONFIG_HAS_ETH2
-#define CONFIG_ETH2ADDR  00:E0:0C:00:02:FD
 #endif
 
 #define CONFIG_IPADDR    192.168.1.253
@@ -425,11 +376,8 @@
 
 #define CONFIG_LOADADDR  200000        /* default location for tftp and bootm */
 
-#define CONFIG_BOOTDELAY 10    /* -1 disables auto-boot */
 #undef  CONFIG_BOOTARGS                /* the boot command will set bootargs */
 
-#define CONFIG_BAUDRATE        115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                                       \
    "netdev=eth0\0"                                                      \
    "consoledev=ttyS0\0"                                                 \