Convert CONFIG_BOOTP_BOOTPATH et al to Kconfig

[people/ms/u-boot.git] / include / configs / MPC8544DS.h

diff --git a/include/configs/MPC8544DS.h b/include/configs/MPC8544DS.h
index c8fec7000dd01985d43603e0335d6aa426a7537d..64e0aa1ca6f6eccd8ee528f1634b867e3769fa97 100644 (file)
--- a/include/configs/MPC8544DS.h
+++ b/include/configs/MPC8544DS.h
@@ -11,17 +11,6 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
-/* High Level Configuration Options */
-#define CONFIG_BOOKE           1       /* BOOKE */
-#define CONFIG_E500            1       /* BOOKE e500 family */
-#define CONFIG_MPC8544         1
-#define CONFIG_MPC8544DS       1
-
-#ifndef CONFIG_SYS_TEXT_BASE
-#define CONFIG_SYS_TEXT_BASE   0xfff80000
-#endif
-
-#define CONFIG_PCI             1       /* Enable PCI/PCIE */
 #define CONFIG_PCI1            1       /* PCI controller 1 */
 #define CONFIG_PCIE1           1       /* PCIE controller 1 (slot 1) */
 #define CONFIG_PCIE2           1       /* PCIE controller 2 (slot 2) */
@@ -31,8 +20,6 @@
 #define CONFIG_FSL_PCIE_RESET  1       /* need PCIe reset errata */
 #define CONFIG_SYS_PCI_64BIT   1       /* enable 64-bit PCI resources */
 
-#define CONFIG_FSL_LAW         1       /* Use common FSL init code */
-
 #define CONFIG_TSEC_ENET               /* tsec ethernet support */
 #define CONFIG_ENV_OVERWRITE
 #define CONFIG_INTERRUPTS              /* enable pci, srio, ddr interrupts */
@@ -55,13 +42,11 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 #define CONFIG_SYS_MEMTEST_START       0x00200000      /* memtest works on */
 #define CONFIG_SYS_MEMTEST_END         0x00400000
-#define CONFIG_PANIC_HANG      /* do not reset board on panic */
 
 #define CONFIG_SYS_CCSRBAR             0xe0000000
 #define CONFIG_SYS_CCSRBAR_PHYS_LOW    CONFIG_SYS_CCSRBAR
 
 /* DDR Setup */
-#define CONFIG_SYS_FSL_DDR2
 #undef CONFIG_FSL_DDR_INTERACTIVE
 #define CONFIG_SPD_EEPROM              /* Use SPD EEPROM for DDR setup */
 #define CONFIG_DDR_SPD
@@ -73,7 +58,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_SDRAM_BASE          CONFIG_SYS_DDR_SDRAM_BASE
 #define CONFIG_VERY_BIG_RAM
 
-#define CONFIG_NUM_DDR_CONTROLLERS     1
 #define CONFIG_DIMM_SLOTS_PER_CTLR     1
 #define CONFIG_CHIP_SELECTS_PER_CTRL   2
 
@@ -275,20 +259,14 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 /*#define VIDEO_IO_OFFSET      CONFIG_SYS_PCI1_IO_VIRT*/
 
 /* video */
-#define CONFIG_VIDEO
 
 #if defined(CONFIG_VIDEO)
 #define CONFIG_BIOSEMU
-#define CONFIG_CFB_CONSOLE
-#define CONFIG_VIDEO_SW_CURSOR
-#define CONFIG_VGA_AS_SINGLE_DEVICE
 #define CONFIG_ATI_RADEON_FB
 #define CONFIG_VIDEO_LOGO
 #define CONFIG_SYS_ISA_IO_BASE_ADDRESS VIDEO_IO_OFFSET
 #endif
 
-#define CONFIG_PCI_PNP                 /* do pci plug-and-play */
-
 #undef CONFIG_EEPRO100
 #undef CONFIG_TULIP
 
@@ -299,11 +277,8 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #endif
 
 #define CONFIG_PCI_SCAN_SHOW           /* show pci devices on startup */
-#define CONFIG_DOS_PARTITION
-#define CONFIG_SCSI_AHCI
 
 #ifdef CONFIG_SCSI_AHCI
-#define CONFIG_LIBATA
 #define CONFIG_SATA_ULI5288
 #define CONFIG_SYS_SCSI_MAX_SCSI_ID    4
 #define CONFIG_SYS_SCSI_MAX_LUN        1
@@ -336,21 +311,18 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define TSEC3_PHYIDX           0
 
 #define CONFIG_ETHPRIME                "eTSEC1"
-
-#define CONFIG_PHY_GIGE                1       /* Include GbE speed/duplex detection */
 #endif /* CONFIG_TSEC_ENET */
 
 /*
  * Environment
  */
-#define CONFIG_ENV_IS_IN_FLASH 1
+#define CONFIG_ENV_SECT_SIZE   0x10000 /* 64K (one sector) */
 #if CONFIG_SYS_MONITOR_BASE > 0xfff80000
 #define CONFIG_ENV_ADDR                0xfff80000
 #else
-#define CONFIG_ENV_ADDR                (CONFIG_SYS_MONITOR_BASE + 0x70000)
+#define CONFIG_ENV_ADDR                (CONFIG_SYS_MONITOR_BASE - CONFIG_ENV_SECT_SIZE)
 #endif
 #define CONFIG_ENV_SIZE                0x2000
-#define CONFIG_ENV_SECT_SIZE   0x10000 /* 64K (one sector) */
 
 #define CONFIG_LOADS_ECHO      1       /* echo on for serial download */
 #define CONFIG_SYS_LOADS_BAUD_CHANGE   1       /* allow baudrate change */
@@ -359,28 +331,12 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
  * BOOTP options
  */
 #define CONFIG_BOOTP_BOOTFILESIZE
-#define CONFIG_BOOTP_BOOTPATH
-#define CONFIG_BOOTP_GATEWAY
-#define CONFIG_BOOTP_HOSTNAME
-
-/*
- * Command line configuration.
- */
-#define CONFIG_CMD_IRQ
-#define CONFIG_CMD_REGINFO
-
-#if defined(CONFIG_PCI)
-    #define CONFIG_CMD_PCI
-    #define CONFIG_SCSI
-#endif
 
 /*
  * USB
  */
-#define CONFIG_USB_EHCI
 
-#ifdef CONFIG_USB_EHCI
-#define CONFIG_USB_EHCI_PCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_PCI_EHCI_DEVICE                 0
 #endif
@@ -390,18 +346,7 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 /*
  * Miscellaneous configurable options
  */
-#define CONFIG_SYS_LONGHELP                    /* undef to save memory */
-#define CONFIG_CMDLINE_EDITING                 /* Command-line editing */
-#define CONFIG_AUTO_COMPLETE                   /* add autocompletion support */
 #define CONFIG_SYS_LOAD_ADDR   0x2000000       /* default load address */
-#if defined(CONFIG_CMD_KGDB)
-#define CONFIG_SYS_CBSIZE      1024            /* Console I/O Buffer Size */
-#else
-#define CONFIG_SYS_CBSIZE      256             /* Console I/O Buffer Size */
-#endif
-#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */
-#define CONFIG_SYS_MAXARGS     16              /* max number of command args */
-#define CONFIG_SYS_BARGSIZE    CONFIG_SYS_CBSIZE       /* Boot Argument Buffer Size */
 
 /*
  * For booting Linux, the board info and command line data
@@ -438,10 +383,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 #define CONFIG_LOADADDR        1000000 /*default location for tftp and bootm*/
 
-#undef CONFIG_BOOTARGS         /* the boot command will set bootargs*/
-
-#define CONFIG_BAUDRATE        115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
 "netdev=eth0\0"                                                \
 "uboot=" __stringify(CONFIG_UBOOTPATH) "\0"                    \