drivers/pci/Kconfig: Add PCI

[people/ms/u-boot.git] / include / configs / MPC8569MDS.h

diff --git a/include/configs/MPC8569MDS.h b/include/configs/MPC8569MDS.h
index 4da247c51aef1b9d19c50d2b171b555ef481c355..fb865ebc14fc134cd68a0a5fda128be2c5cfbb32 100644 (file)
--- a/include/configs/MPC8569MDS.h
+++ b/include/configs/MPC8569MDS.h
@@ -21,7 +21,6 @@
 #define CONFIG_SYS_SRIO
 #define CONFIG_SRIO1                   /* SRIO port 1 */
 
-#define CONFIG_PCI             1       /* Disable PCI/PCIE */
 #define CONFIG_PCIE1           1       /* PCIE controller */
 #define CONFIG_FSL_PCI_INIT    1       /* use common fsl pci init code */
 #define CONFIG_PCI_INDIRECT_BRIDGE 1   /* indirect PCI bridge support */
@@ -194,7 +193,6 @@ extern unsigned long get_clock_freq(void);
 #define CONFIG_SYS_NAND_BASE_PHYS      CONFIG_SYS_NAND_BASE
 #define CONFIG_SYS_NAND_BASE_LIST      { CONFIG_SYS_NAND_BASE, }
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
-#define CONFIG_MTD_NAND_VERIFY_WRITE   1
 #define CONFIG_CMD_NAND                        1
 #define CONFIG_NAND_FSL_ELBC           1
 #define CONFIG_SYS_NAND_BLOCK_SIZE     (128 * 1024)
@@ -234,7 +232,6 @@ extern unsigned long get_clock_freq(void);
 
 /* Serial Port */
 #define CONFIG_CONS_INDEX              1
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE    1
 #define CONFIG_SYS_NS16550_CLK         get_bus_freq(0)
@@ -248,16 +245,6 @@ extern unsigned long get_clock_freq(void);
 #define CONFIG_SYS_NS16550_COM1        (CONFIG_SYS_CCSRBAR+0x4500)
 #define CONFIG_SYS_NS16550_COM2        (CONFIG_SYS_CCSRBAR+0x4600)
 
-/* Use the HUSH parser*/
-#define CONFIG_SYS_HUSH_PARSER
-#ifdef  CONFIG_SYS_HUSH_PARSER
-#endif
-
-/* pass open firmware flat tree */
-#define CONFIG_OF_LIBFDT               1
-#define CONFIG_OF_BOARD_SETUP          1
-#define CONFIG_OF_STDOUT_VIA_ALIAS     1
-
 /*
  * I2C
  */
@@ -442,7 +429,6 @@ extern unsigned long get_clock_freq(void);
 
 #undef CONFIG_EEPRO100
 #undef CONFIG_TULIP
-#define CONFIG_E1000                   /* Define e1000 pci Ethernet card */
 
 #undef CONFIG_PCI_SCAN_SHOW            /* show pci devices on startup */
 
@@ -474,25 +460,16 @@ extern unsigned long get_clock_freq(void);
 #define CONFIG_BOOTP_GATEWAY
 #define CONFIG_BOOTP_HOSTNAME
 
-
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
-#define CONFIG_CMD_PING
-#define CONFIG_CMD_I2C
-#define CONFIG_CMD_MII
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_IRQ
-#define CONFIG_CMD_SETEXPR
 #define CONFIG_CMD_REGINFO
 
 #if defined(CONFIG_PCI)
     #define CONFIG_CMD_PCI
 #endif
 
-
 #undef CONFIG_WATCHDOG                 /* watchdog disabled */
 
 #define CONFIG_MMC     1
@@ -501,10 +478,7 @@ extern unsigned long get_clock_freq(void);
 #define CONFIG_FSL_ESDHC
 #define CONFIG_FSL_ESDHC_PIN_MUX
 #define CONFIG_SYS_FSL_ESDHC_ADDR      CONFIG_SYS_MPC85xx_ESDHC_ADDR
-#define CONFIG_CMD_MMC
 #define CONFIG_GENERIC_MMC
-#define CONFIG_CMD_EXT2
-#define CONFIG_CMD_FAT
 #define CONFIG_DOS_PARTITION
 #endif
 
@@ -551,7 +525,6 @@ extern unsigned long get_clock_freq(void);
 
 #define CONFIG_LOADADDR  200000   /*default location for tftp and bootm*/
 
-#define CONFIG_BOOTDELAY 10       /* -1 disables auto-boot */
 #undef  CONFIG_BOOTARGS           /* the boot command will set bootargs*/
 
 #define CONFIG_BAUDRATE        115200