configs: Re-sync with cmd/Kconfig

[people/ms/u-boot.git] / include / configs / P1010RDB.h

diff --git a/include/configs/P1010RDB.h b/include/configs/P1010RDB.h
index 8ac7000989eb843b7022d937e176f692f06240f2..5719e86f1bcf3961b06842bffea9b35fb22f0e85 100644 (file)
--- a/include/configs/P1010RDB.h
+++ b/include/configs/P1010RDB.h
@@ -14,7 +14,6 @@
 #ifdef CONFIG_36BIT
 #define CONFIG_PHYS_64BIT
 #endif
-#define        CONFIG_SYS_GENERIC_BOARD
 #define        CONFIG_DISPLAY_BOARDINFO
 
 #define CONFIG_P1010
@@ -186,7 +185,6 @@
 
 #define CONFIG_CMD_PCI
 
-
 /*
  * PCI Windows
  * Memory space is mapped 1-1, but I/O space must start from 0.
@@ -556,9 +554,9 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_SYS_INIT_RAM_LOCK
 #define CONFIG_SYS_INIT_RAM_ADDR       0xffd00000 /* stack in RAM */
-#define CONFIG_SYS_INIT_RAM_END                0x00004000 /* End of used area in RAM */
+#define CONFIG_SYS_INIT_RAM_SIZE       0x00004000 /* End of used area in RAM */
 
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END \
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE \
                                                - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      CONFIG_SYS_GBL_DATA_OFFSET
 
@@ -605,7 +603,6 @@ extern unsigned long get_sdram_size(void);
 /* Serial Port */
 #define CONFIG_CONS_INDEX      1
 #undef CONFIG_SERIAL_SOFTWARE_FIFO
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE    1
 #define CONFIG_SYS_NS16550_CLK         get_bus_freq(0)
@@ -621,20 +618,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_NS16550_COM1        (CONFIG_SYS_CCSRBAR+0x4500)
 #define CONFIG_SYS_NS16550_COM2        (CONFIG_SYS_CCSRBAR+0x4600)
 
-/* Use the HUSH parser */
-#define CONFIG_SYS_HUSH_PARSER
-
-/*
- * Pass open firmware flat tree
- */
-#define CONFIG_OF_LIBFDT
-#define CONFIG_OF_BOARD_SETUP
-#define CONFIG_OF_STDOUT_VIA_ALIAS
-
-/* new uImage format support */
-#define CONFIG_FIT
-#define CONFIG_FIT_VERBOSE     /* enable fit_format_{error,warning}() */
-
 /* I2C */
 #define CONFIG_SYS_I2C
 #define CONFIG_SYS_I2C_FSL
@@ -661,7 +644,6 @@ extern unsigned long get_sdram_size(void);
 #endif
 /* enable read and write access to EEPROM */
 #define CONFIG_CMD_EEPROM
-#define CONFIG_SYS_I2C_MULTI_EEPROMS
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -670,17 +652,12 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_RTC_PT7C4338
 #define CONFIG_SYS_I2C_RTC_ADDR        0x68
 
-#define CONFIG_CMD_I2C
-
 /*
  * SPI interface will not be available in case of NAND boot SPI CS0 will be
  * used for SLIC
  */
 #if !defined(CONFIG_NAND) || !defined(CONFIG_NAND_SECBOOT)
 /* eSPI - Enhanced SPI */
-#define CONFIG_FSL_ESPI
-#define CONFIG_SPI_FLASH_SPANSION
-#define CONFIG_CMD_SF
 #define CONFIG_SF_DEFAULT_SPEED                10000000
 #define CONFIG_SF_DEFAULT_MODE         SPI_MODE_0
 #endif
@@ -721,7 +698,6 @@ extern unsigned long get_sdram_size(void);
 
 #endif /* CONFIG_TSEC_ENET */
 
-
 /* SATA */
 #define CONFIG_FSL_SATA
 #define CONFIG_FSL_SATA_V2
@@ -742,7 +718,6 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_MMC
 #ifdef CONFIG_MMC
-#define CONFIG_CMD_MMC
 #define CONFIG_DOS_PARTITION
 #define CONFIG_FSL_ESDHC
 #define CONFIG_GENERIC_MMC
@@ -755,7 +730,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_USB_EHCI
 
 #ifdef CONFIG_USB_EHCI
-#define CONFIG_CMD_USB
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #define CONFIG_USB_STORAGE
@@ -813,18 +787,13 @@ extern unsigned long get_sdram_size(void);
  */
 #define CONFIG_CMD_DATE
 #define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_IRQ
-#define CONFIG_CMD_MII
-#define CONFIG_CMD_PING
 #define CONFIG_CMD_REGINFO
 
 #undef CONFIG_WATCHDOG                 /* watchdog disabled */
 
 #if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI) \
                 || defined(CONFIG_FSL_SATA)
-#define CONFIG_CMD_EXT2
-#define CONFIG_CMD_FAT
 #define CONFIG_DOS_PARTITION
 #endif
 
@@ -958,8 +927,4 @@ extern unsigned long get_sdram_size(void);
 
 #include <asm/fsl_secure_boot.h>
 
-#ifdef CONFIG_SECURE_BOOT
-#define CONFIG_CMD_BLOB
-#endif
-
 #endif /* __CONFIG_H */