Move CONFIG_OF_LIBFDT to Kconfig

[people/ms/u-boot.git] / include / configs / P1022DS.h

diff --git a/include/configs/P1022DS.h b/include/configs/P1022DS.h
index 139d4fed2516784602f8225372dd2c306b41f400..3aa10d1b43eb9f4265c1990b574dd9ebb91f55d4 100644 (file)
--- a/include/configs/P1022DS.h
+++ b/include/configs/P1022DS.h
@@ -11,12 +11,13 @@
 
 #include "../board/freescale/common/ics307_clk.h"
 
+#define CONFIG_DISPLAY_BOARDINFO
+
 #ifdef CONFIG_36BIT
 #define CONFIG_PHYS_64BIT
 #endif
 
 #ifdef CONFIG_SDCARD
-#define CONFIG_SPL
 #define CONFIG_SPL_MPC8XXX_INIT_DDR_SUPPORT
 #define CONFIG_SPL_ENV_SUPPORT
 #define CONFIG_SPL_SERIAL_SUPPORT
@@ -45,7 +46,6 @@
 #endif
 
 #ifdef CONFIG_SPIFLASH
-#define CONFIG_SPL
 #define CONFIG_SPL_MPC8XXX_INIT_DDR_SUPPORT
 #define CONFIG_SPL_ENV_SUPPORT
 #define CONFIG_SPL_SERIAL_SUPPORT
@@ -79,8 +79,6 @@
 #define CONFIG_SYS_NAND_MAX_OOBFREE    5
 
 #ifdef CONFIG_NAND
-#define CONFIG_SPL
-#define CONFIG_TPL
 #ifdef CONFIG_TPL_BUILD
 #define CONFIG_SPL_NAND_BOOT
 #define CONFIG_SPL_FLUSH_IMAGE
@@ -291,7 +289,6 @@
 
 #define CONFIG_SYS_NAND_BASE_LIST      {CONFIG_SYS_NAND_BASE}
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
-#define CONFIG_MTD_NAND_VERIFY_WRITE
 #define CONFIG_CMD_NAND                        1
 #define CONFIG_SYS_NAND_BLOCK_SIZE     (256 * 1024)
 #define CONFIG_ELBC_NAND_SPL_STATIC_PGSIZE
@@ -352,7 +349,7 @@
        (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      CONFIG_SYS_GBL_DATA_OFFSET
 
-#define CONFIG_SYS_MONITOR_LEN         (512 * 1024)
+#define CONFIG_SYS_MONITOR_LEN         (768 * 1024)
 #define CONFIG_SYS_MALLOC_LEN          (10 * 1024 * 1024)
 
 /*
@@ -396,7 +393,6 @@
  * Serial Port
  */
 #define CONFIG_CONS_INDEX              1
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE    1
 #define CONFIG_SYS_NS16550_CLK         get_bus_freq(0)
@@ -450,7 +446,6 @@
 /*
  * Pass open firmware flat tree
  */
-#define CONFIG_OF_LIBFDT
 #define CONFIG_OF_BOARD_SETUP
 #define CONFIG_OF_STDOUT_VIA_ALIAS
 
@@ -481,11 +476,8 @@
 /*
  * eSPI - Enhanced SPI
  */
-#define CONFIG_SPI_FLASH
-#define CONFIG_SPI_FLASH_SPANSION
 
 #define CONFIG_HARD_SPI
-#define CONFIG_FSL_ESPI
 
 #define CONFIG_CMD_SF
 #define CONFIG_SF_DEFAULT_SPEED                10000000
@@ -557,7 +549,6 @@
 #define CONFIG_PCI_INDIRECT_BRIDGE
 #define CONFIG_PCI_PNP                 /* do pci plug-and-play */
 #define CONFIG_PCI_SCAN_SHOW           /* show pci devices on startup */
-#define CONFIG_E1000                   /* Define e1000 pci Ethernet card */
 #endif
 
 /* SATA */
@@ -619,6 +610,25 @@
 #define CONFIG_PHY_GIGE                /* Include GbE speed/duplex detection */
 #endif
 
+/*
+ * Dynamic MTD Partition support with mtdparts
+ */
+#define CONFIG_MTD_DEVICE
+#define CONFIG_MTD_PARTITIONS
+#define CONFIG_CMD_MTDPARTS
+#define CONFIG_FLASH_CFI_MTD
+#ifdef CONFIG_PHYS_64BIT
+#define MTDIDS_DEFAULT "nor0=fe8000000.nor"
+#define MTDPARTS_DEFAULT "mtdparts=fe8000000.nor:48m(ramdisk)," \
+                       "14m(diagnostic),2m(dink),6m(kernel),58112k(fs)," \
+                       "512k(dtb),768k(u-boot)"
+#else
+#define MTDIDS_DEFAULT "nor0=e8000000.nor"
+#define MTDPARTS_DEFAULT "mtdparts=e8000000.nor:48m(ramdisk)," \
+                       "14m(diagnostic),2m(dink),6m(kernel),58112k(fs)," \
+                       "512k(dtb),768k(u-boot)"
+#endif
+
 /*
  * Environment
  */
@@ -663,20 +673,15 @@
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_ERRATA
 #define CONFIG_CMD_IRQ
 #define CONFIG_CMD_I2C
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_PING
-#define CONFIG_CMD_SETEXPR
 #define CONFIG_CMD_REGINFO
 
 #ifdef CONFIG_PCI
 #define CONFIG_CMD_PCI
-#define CONFIG_CMD_NET
 #endif
 
 /*