Move CONFIG_OF_LIBFDT to Kconfig

[people/ms/u-boot.git] / include / configs / T102xRDB.h

diff --git a/include/configs/T102xRDB.h b/include/configs/T102xRDB.h
index b67836c2813cfe8cb237358b923447100de12f03..92ad71fbebbf404b8cf6940962d7e6d910704182 100644 (file)
--- a/include/configs/T102xRDB.h
+++ b/include/configs/T102xRDB.h
@@ -11,14 +11,7 @@
 #ifndef __T1024RDB_H
 #define __T1024RDB_H
 
-#if defined(CONFIG_T1023RDB)
-#ifdef CONFIG_SPL
-#define CONFIG_SYS_NO_FLASH
-#endif
-#endif
-
 /* High Level Configuration Options */
-#define CONFIG_SYS_GENERIC_BOARD
 #define CONFIG_DISPLAY_BOARDINFO
 #define CONFIG_BOOKE
 #define CONFIG_E500                    /* BOOKE e500 family */
@@ -40,6 +33,8 @@
 #define CONFIG_FSL_LAW                 /* Use common FSL init code */
 #define CONFIG_ENV_OVERWRITE
 
+#define CONFIG_FSL_CAAM                        /* Enable SEC/CAAM */
+
 /* support deep sleep */
 #ifdef CONFIG_PPC_T1024
 #define CONFIG_DEEP_SLEEP
@@ -320,7 +315,7 @@ unsigned long get_board_ddr_clk(void);
 #if defined(CONFIG_T1024RDB)
 #define CONFIG_SYS_NOR_CSOR    CSOR_NAND_TRHZ_80
 #elif defined(CONFIG_T1023RDB)
-#define CONFIG_SYS_NOR_CSOR    (CSOR_NOR_ADM_SHIFT(4) | \
+#define CONFIG_SYS_NOR_CSOR    (CSOR_NOR_ADM_SHIFT(0) | \
                                CSOR_NAND_TRHZ_80 | CSOR_NOR_ADM_SHFT_MODE_EN)
 #endif
 #define CONFIG_SYS_NOR_FTIM0   (FTIM0_NOR_TACSE(0x4) | \
@@ -482,13 +477,13 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_SYS_INIT_RAM_ADDR       0xfdd00000      /* Initial L1 address */
 #ifdef CONFIG_PHYS_64BIT
 #define CONFIG_SYS_INIT_RAM_ADDR_PHYS_HIGH     0xf
-#define CONFIG_SYS_INIT_RAM_ADDR_PHYS_LOW      0xfe0ec000
+#define CONFIG_SYS_INIT_RAM_ADDR_PHYS_LOW      0xfe03c000
 /* The assembler doesn't like typecast */
 #define CONFIG_SYS_INIT_RAM_ADDR_PHYS \
        ((CONFIG_SYS_INIT_RAM_ADDR_PHYS_HIGH * 1ull << 32) | \
          CONFIG_SYS_INIT_RAM_ADDR_PHYS_LOW)
 #else
-#define CONFIG_SYS_INIT_RAM_ADDR_PHYS  0xfe0ec000 /* Initial L1 address */
+#define CONFIG_SYS_INIT_RAM_ADDR_PHYS  0xfe03c000 /* Initial L1 address */
 #define CONFIG_SYS_INIT_RAM_ADDR_PHYS_HIGH 0
 #define CONFIG_SYS_INIT_RAM_ADDR_PHYS_LOW CONFIG_SYS_INIT_RAM_ADDR_PHYS
 #endif
@@ -503,7 +498,6 @@ unsigned long get_board_ddr_clk(void);
 
 /* Serial Port */
 #define CONFIG_CONS_INDEX      1
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE    1
 #define CONFIG_SYS_NS16550_CLK         (get_bus_freq(0)/2)
@@ -541,7 +535,6 @@ unsigned long get_board_ddr_clk(void);
 #endif
 
 /* pass open firmware flat tree */
-#define CONFIG_OF_LIBFDT
 #define CONFIG_OF_BOARD_SETUP
 #define CONFIG_OF_STDOUT_VIA_ALIAS
 
@@ -559,9 +552,8 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_SYS_FSL_I2C_OFFSET      0x118000
 #define CONFIG_SYS_FSL_I2C2_OFFSET     0x118100
 
-#define I2C_MUX_PCA_ADDR               0x77
-#define I2C_MUX_PCA_ADDR_PRI           0x77 /* Primary Mux*/
-
+#define I2C_PCA6408_BUS_NUM            1
+#define I2C_PCA6408_ADDR               0x20
 
 /* I2C bus multiplexer */
 #define I2C_MUX_CH_DEFAULT     0x8
@@ -576,11 +568,8 @@ unsigned long get_board_ddr_clk(void);
 /*
  * eSPI - Enhanced SPI
  */
-#define CONFIG_FSL_ESPI
 #if defined(CONFIG_T1024RDB)
-#define CONFIG_SPI_FLASH_STMICRO
 #elif defined(CONFIG_T1023RDB)
-#define CONFIG_SPI_FLASH_SPANSION
 #endif
 #define CONFIG_CMD_SF
 #define CONFIG_SPI_FLASH_BAR
@@ -688,7 +677,6 @@ unsigned long get_board_ddr_clk(void);
 #endif
 
 #define CONFIG_PCI_PNP                 /* do pci plug-and-play */
-#define CONFIG_E1000
 #define CONFIG_PCI_SCAN_SHOW           /* show pci devices on startup */
 #define CONFIG_DOS_PARTITION
 #endif /* CONFIG_PCI */
@@ -759,8 +747,10 @@ unsigned long get_board_ddr_clk(void);
 
 #define CONFIG_SYS_DPAA_FMAN
 
+#ifdef CONFIG_T1024RDB
 #define CONFIG_QE
 #define CONFIG_U_QE
+#endif
 /* Default address of microcode for the Linux FMan driver */
 #if defined(CONFIG_SPIFLASH)
 /*
@@ -858,7 +848,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_CMD_DATE
 #define CONFIG_CMD_DHCP
 #define CONFIG_CMD_EEPROM
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_ERRATA
 #define CONFIG_CMD_GREPENV
 #define CONFIG_CMD_IRQ
@@ -878,7 +867,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_CMDLINE_EDITING                 /* Command-line editing */
 #define CONFIG_AUTO_COMPLETE                   /* add autocompletion support */
 #define CONFIG_SYS_LOAD_ADDR   0x2000000       /* default load address */
-#define CONFIG_SYS_PROMPT      "=> "           /* Monitor Command Prompt */
 #ifdef CONFIG_CMD_KGDB
 #define CONFIG_SYS_CBSIZE      1024            /* Console I/O Buffer Size */
 #else
@@ -961,8 +949,12 @@ unsigned long get_board_ddr_clk(void);
 
 #define CONFIG_BOOTCOMMAND     CONFIG_LINUX
 
-#ifdef CONFIG_SECURE_BOOT
-#include <asm/fsl_secure_boot.h>
+/* Hash command with SHA acceleration supported in hardware */
+#ifdef CONFIG_FSL_CAAM
+#define CONFIG_CMD_HASH
+#define CONFIG_SHA_HW_ACCEL
 #endif
 
+#include <asm/fsl_secure_boot.h>
+
 #endif /* __T1024RDB_H */