configs: Re-sync with cmd/Kconfig

[people/ms/u-boot.git] / include / configs / T208xRDB.h

diff --git a/include/configs/T208xRDB.h b/include/configs/T208xRDB.h
index ef42b88854e1b8709d061cb392b02cfb90465c8e..5e2d65975df2792d8fb5801a27f95094df99bc3a 100644 (file)
--- a/include/configs/T208xRDB.h
+++ b/include/configs/T208xRDB.h
@@ -11,7 +11,6 @@
 #ifndef __T2080RDB_H
 #define __T2080RDB_H
 
-#define CONFIG_SYS_GENERIC_BOARD
 #define CONFIG_DISPLAY_BOARDINFO
 #define CONFIG_T2080RDB
 #define CONFIG_ICS307_REFCLK_HZ 25000000  /* ICS307 ref clk freq */
@@ -139,7 +138,6 @@
 #define CONFIG_MEM_INIT_VALUE          0xdeadbeef
 #endif
 
-#define CONFIG_CMD_MEMTEST
 #define CONFIG_SYS_MEMTEST_START       0x00200000 /* memtest works on */
 #define CONFIG_SYS_MEMTEST_END         0x00400000
 #define CONFIG_SYS_ALT_MEMTEST
@@ -406,7 +404,6 @@ unsigned long get_board_ddr_clk(void);
  * Serial Port
  */
 #define CONFIG_CONS_INDEX              1
-#define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE    1
 #define CONFIG_SYS_NS16550_CLK         (get_bus_freq(0)/2)
@@ -417,19 +414,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_SYS_NS16550_COM3 (CONFIG_SYS_CCSRBAR+0x11D500)
 #define CONFIG_SYS_NS16550_COM4 (CONFIG_SYS_CCSRBAR+0x11D600)
 
-/* Use the HUSH parser */
-#define CONFIG_SYS_HUSH_PARSER
-#define CONFIG_SYS_PROMPT_HUSH_PS2 "> "
-
-/* pass open firmware flat tree */
-#define CONFIG_OF_LIBFDT
-#define CONFIG_OF_BOARD_SETUP
-#define CONFIG_OF_STDOUT_VIA_ALIAS
-
-/* new uImage format support */
-#define CONFIG_FIT
-#define CONFIG_FIT_VERBOSE     /* enable fit_format_{error,warning}() */
-
 /*
  * I2C
  */
@@ -506,10 +490,7 @@ unsigned long get_board_ddr_clk(void);
  * eSPI - Enhanced SPI
  */
 #ifdef CONFIG_SPI_FLASH
-#define CONFIG_FSL_ESPI
-#define CONFIG_SPI_FLASH_STMICRO
 #define CONFIG_SPI_FLASH_BAR
-#define CONFIG_CMD_SF
 #define CONFIG_SF_DEFAULT_SPEED         10000000
 #define CONFIG_SF_DEFAULT_MODE   0
 #endif
@@ -671,7 +652,6 @@ unsigned long get_board_ddr_clk(void);
 #define FM1_10GEC4_PHY_ADDR    0x01
 #endif
 
-
 #ifdef CONFIG_FMAN_ENET
 #define CONFIG_MII             /* MII PHY management */
 #define CONFIG_ETHPRIME                "FM1@DTSEC3"
@@ -694,18 +674,15 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_LBA48
 #define CONFIG_CMD_SATA
 #define CONFIG_DOS_PARTITION
-#define CONFIG_CMD_EXT2
 #endif
 
 /*
  * USB
  */
 #ifdef CONFIG_USB_EHCI
-#define CONFIG_CMD_USB
 #define CONFIG_USB_STORAGE
 #define CONFIG_USB_EHCI_FSL
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
-#define CONFIG_CMD_EXT2
 #define CONFIG_HAS_FSL_DR_USB
 #endif
 
@@ -713,14 +690,11 @@ unsigned long get_board_ddr_clk(void);
  * SDHC
  */
 #ifdef CONFIG_MMC
-#define CONFIG_CMD_MMC
 #define CONFIG_FSL_ESDHC
 #define CONFIG_SYS_FSL_ESDHC_ADDR      CONFIG_SYS_MPC85xx_ESDHC_ADDR
 #define CONFIG_SYS_FSL_ESDHC_BROKEN_TIMEOUT
 #define CONFIG_SYS_FSL_MMC_HAS_CAPBLT_VS33
 #define CONFIG_GENERIC_MMC
-#define CONFIG_CMD_EXT2
-#define CONFIG_CMD_FAT
 #define CONFIG_DOS_PARTITION
 #endif
 
@@ -747,12 +721,7 @@ unsigned long get_board_ddr_clk(void);
 /*
  * Command line configuration.
  */
-#define CONFIG_CMD_DHCP
-#define CONFIG_CMD_ELF
 #define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_MII
-#define CONFIG_CMD_I2C
-#define CONFIG_CMD_PING
 #define CONFIG_CMD_REGINFO
 
 #ifdef CONFIG_PCI
@@ -894,10 +863,6 @@ unsigned long get_board_ddr_clk(void);
 
 #define CONFIG_BOOTCOMMAND             CONFIG_LINUX
 
-#ifdef CONFIG_SECURE_BOOT
 #include <asm/fsl_secure_boot.h>
-#define CONFIG_CMD_BLOB
-#undef CONFIG_CMD_USB
-#endif
 
 #endif /* __T2080RDB_H */