#ifndef __CONFIG_H
#define __CONFIG_H
-#include <config_cmd_default.h>
-
#define CONFIG_LS102XA
-#define CONFIG_SYS_GENERIC_BOARD
+#define CONFIG_ARMV7_PSCI
+
+#define CONFIG_SYS_FSL_CLK
#define CONFIG_DISPLAY_CPUINFO
#define CONFIG_DISPLAY_BOARDINFO
#define CONFIG_SKIP_LOWLEVEL_INIT
#define CONFIG_BOARD_EARLY_INIT_F
+#define CONFIG_DEEP_SLEEP
+#ifdef CONFIG_DEEP_SLEEP
+#define CONFIG_SILENT_CONSOLE
+#endif
/*
* Size of malloc() pool
#define CONFIG_SYS_INIT_RAM_ADDR OCRAM_BASE_ADDR
#define CONFIG_SYS_INIT_RAM_SIZE OCRAM_SIZE
+/*
+ * USB
+ */
+
+/*
+ * EHCI Support - disbaled by default as
+ * there is no signal coming out of soc on
+ * this board for this controller. However,
+ * the silicon still has this controller,
+ * and anyone can use this controller by
+ * taking signals out on their board.
+ */
+
+/*#define CONFIG_HAS_FSL_DR_USB*/
+
+#ifdef CONFIG_HAS_FSL_DR_USB
+#define CONFIG_USB_EHCI
+#define CONFIG_USB_EHCI_FSL
+#define CONFIG_EHCI_HCD_INIT_AFTER_RESET
+#endif
+
+/* XHCI Support - enabled by default */
+#define CONFIG_HAS_FSL_XHCI_USB
+
+#ifdef CONFIG_HAS_FSL_XHCI_USB
+#define CONFIG_USB_XHCI_FSL
+#define CONFIG_USB_XHCI_DWC3
+#define CONFIG_USB_XHCI
+#define CONFIG_USB_MAX_CONTROLLER_COUNT 1
+#define CONFIG_SYS_USB_XHCI_MAX_ROOT_PORTS 2
+#endif
+
+#if defined(CONFIG_HAS_FSL_DR_USB) || defined(CONFIG_HAS_FSL_XHCI_USB)
+#define CONFIG_CMD_USB
+#define CONFIG_USB_STORAGE
+#define CONFIG_CMD_EXT2
+#endif
+
/*
* Generic Timer Definitions
*/
#define CONFIG_SYS_CLK_FREQ 100000000
#define CONFIG_DDR_CLK_FREQ 100000000
+#define DDR_SDRAM_CFG 0x470c0008
+#define DDR_CS0_BNDS 0x008000bf
+#define DDR_CS0_CONFIG 0x80014302
+#define DDR_TIMING_CFG_0 0x50550004
+#define DDR_TIMING_CFG_1 0xbcb38c56
+#define DDR_TIMING_CFG_2 0x0040d120
+#define DDR_TIMING_CFG_3 0x010e1000
+#define DDR_TIMING_CFG_4 0x00000001
+#define DDR_TIMING_CFG_5 0x03401400
+#define DDR_SDRAM_CFG_2 0x00401010
+#define DDR_SDRAM_MODE 0x00061c60
+#define DDR_SDRAM_MODE_2 0x00180000
+#define DDR_SDRAM_INTERVAL 0x18600618
+#define DDR_DDR_WRLVL_CNTL 0x8655f605
+#define DDR_DDR_WRLVL_CNTL_2 0x05060607
+#define DDR_DDR_WRLVL_CNTL_3 0x05050505
+#define DDR_DDR_CDR1 0x80040000
+#define DDR_DDR_CDR2 0x00000001
+#define DDR_SDRAM_CLK_CNTL 0x02000000
+#define DDR_DDR_ZQ_CNTL 0x89080600
+#define DDR_CS0_CONFIG_2 0
+#define DDR_SDRAM_CFG_MEM_EN 0x80000000
+#define SDRAM_CFG2_D_INIT 0x00000010
+#define DDR_CDR2_VREF_TRAIN_EN 0x00000080
+#define SDRAM_CFG2_FRC_SR 0x80000000
+#define SDRAM_CFG_BI 0x00000001
+
#ifdef CONFIG_RAMBOOT_PBL
#define CONFIG_SYS_FSL_PBL_PBI board/freescale/ls1021atwr/ls102xa_pbi.cfg
#endif
#ifdef CONFIG_SD_BOOT
-#define CONFIG_SYS_FSL_PBL_RCW board/freescale/ls1021atwr/ls102xa_rcw_sd.cfg
+#ifdef CONFIG_SD_BOOT_QSPI
+#define CONFIG_SYS_FSL_PBL_RCW \
+ board/freescale/ls1021atwr/ls102xa_rcw_sd_qspi.cfg
+#else
+#define CONFIG_SYS_FSL_PBL_RCW \
+ board/freescale/ls1021atwr/ls102xa_rcw_sd_ifc.cfg
+#endif
#define CONFIG_SPL_FRAMEWORK
#define CONFIG_SPL_LDSCRIPT "arch/$(ARCH)/cpu/u-boot-spl.lds"
#define CONFIG_SPL_LIBCOMMON_SUPPORT
#define CONFIG_SPL_PAD_TO 0x1c000
#define CONFIG_SYS_TEXT_BASE 0x82000000
-#define CONFIG_SYS_SPL_MALLOC_START 0x80200000
+#define CONFIG_SYS_SPL_MALLOC_START (CONFIG_SYS_TEXT_BASE + \
+ CONFIG_SYS_MONITOR_LEN)
#define CONFIG_SYS_SPL_MALLOC_SIZE 0x100000
#define CONFIG_SPL_BSS_START_ADDR 0x80100000
#define CONFIG_SPL_BSS_MAX_SIZE 0x80000
#ifdef CONFIG_QSPI_BOOT
#define CONFIG_SYS_TEXT_BASE 0x40010000
+#endif
+
+#if defined(CONFIG_QSPI_BOOT) || defined(CONFIG_SD_BOOT_QSPI)
#define CONFIG_SYS_NO_FLASH
#endif
#ifndef CONFIG_SYS_TEXT_BASE
-#define CONFIG_SYS_TEXT_BASE 0x67f80000
+#define CONFIG_SYS_TEXT_BASE 0x60100000
#endif
#define CONFIG_NR_DRAM_BANKS 1
/*
* IFC Definitions
*/
-#ifndef CONFIG_QSPI_BOOT
+#if !defined(CONFIG_QSPI_BOOT) && !defined(CONFIG_SD_BOOT_QSPI)
#define CONFIG_FSL_IFC
#define CONFIG_SYS_FLASH_BASE 0x60000000
#define CONFIG_SYS_FLASH_BASE_PHYS CONFIG_SYS_FLASH_BASE
* Serial Port
*/
#ifdef CONFIG_LPUART
-#define CONFIG_FSL_LPUART
#define CONFIG_LPUART_32B_REG
#else
#define CONFIG_CONS_INDEX 1
-#define CONFIG_SYS_NS16550
#define CONFIG_SYS_NS16550_SERIAL
+#ifndef CONFIG_DM_SERIAL
#define CONFIG_SYS_NS16550_REG_SIZE 1
+#endif
#define CONFIG_SYS_NS16550_CLK get_serial_clock()
#endif
#define CONFIG_CMD_I2C
#define CONFIG_SYS_I2C
#define CONFIG_SYS_I2C_MXC
+#define CONFIG_SYS_I2C_MXC_I2C1 /* enable I2C bus 1 */
+#define CONFIG_SYS_I2C_MXC_I2C2 /* enable I2C bus 2 */
+#define CONFIG_SYS_I2C_MXC_I2C3 /* enable I2C bus 3 */
/* EEPROM */
-#ifndef CONFIG_SD_BOOT
#define CONFIG_ID_EEPROM
#define CONFIG_SYS_I2C_EEPROM_NXID
#define CONFIG_SYS_EEPROM_BUS_NUM 1
#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
-#endif
/*
* MMC
#define CONFIG_CMD_FAT
#define CONFIG_DOS_PARTITION
+/* SPI */
+#if defined(CONFIG_QSPI_BOOT) || defined(CONFIG_SD_BOOT_QSPI)
/* QSPI */
-#ifdef CONFIG_QSPI_BOOT
-#define CONFIG_FSL_QSPI
#define QSPI0_AMBA_BASE 0x40000000
#define FSL_QSPI_FLASH_SIZE (1 << 24)
#define FSL_QSPI_FLASH_NUM 2
+/* DSPI */
+#endif
+
+/* DM SPI */
+#if defined(CONFIG_FSL_DSPI) || defined(CONFIG_FSL_QSPI)
#define CONFIG_CMD_SF
-#define CONFIG_SPI_FLASH
-#define CONFIG_SPI_FLASH_STMICRO
+#define CONFIG_DM_SPI_FLASH
#endif
/*
#define CONFIG_PCIE_LAYERSCAPE /* Use common FSL Layerscape PCIe code */
#define FSL_PCIE_COMPAT "fsl,ls1021a-pcie"
+#define CONFIG_SYS_PCI_64BIT
+
+#define CONFIG_SYS_PCIE_CFG0_PHYS_OFF 0x00000000
+#define CONFIG_SYS_PCIE_CFG0_SIZE 0x00001000 /* 4k */
+#define CONFIG_SYS_PCIE_CFG1_PHYS_OFF 0x00001000
+#define CONFIG_SYS_PCIE_CFG1_SIZE 0x00001000 /* 4k */
+
+#define CONFIG_SYS_PCIE_IO_BUS 0x00000000
+#define CONFIG_SYS_PCIE_IO_PHYS_OFF 0x00010000
+#define CONFIG_SYS_PCIE_IO_SIZE 0x00010000 /* 64k */
+
+#define CONFIG_SYS_PCIE_MEM_BUS 0x08000000
+#define CONFIG_SYS_PCIE_MEM_PHYS_OFF 0x04000000
+#define CONFIG_SYS_PCIE_MEM_SIZE 0x08000000 /* 128M */
+
+#ifdef CONFIG_PCI
+#define CONFIG_PCI_PNP
+#define CONFIG_PCI_SCAN_SHOW
+#define CONFIG_CMD_PCI
+#endif
+
#define CONFIG_CMD_PING
#define CONFIG_CMD_DHCP
#define CONFIG_CMD_MII
-#define CONFIG_CMD_NET
#define CONFIG_CMDLINE_TAG
#define CONFIG_CMDLINE_EDITING
-#ifdef CONFIG_QSPI_BOOT
+#if defined(CONFIG_QSPI_BOOT) || defined(CONFIG_SD_BOOT_QSPI)
#undef CONFIG_CMD_IMLS
-#else
-#define CONFIG_CMD_IMLS
#endif
#define CONFIG_ARMV7_NONSEC
#define CONFIG_ARMV7_VIRT
#define CONFIG_PEN_ADDR_BIG_ENDIAN
-#define CONFIG_LS102XA_NS_ACCESS
+#define CONFIG_LAYERSCAPE_NS_ACCESS
#define CONFIG_SMP_PEN_ADDR 0x01ee0200
#define CONFIG_TIMER_CLK_FREQ 12500000
-#define CONFIG_ARMV7_SECURE_BASE OCRAM_BASE_S_ADDR
#define CONFIG_HWCONFIG
-#define HWCONFIG_BUFFER_SIZE 128
+#define HWCONFIG_BUFFER_SIZE 256
+
+#define CONFIG_FSL_DEVICE_DISABLE
#define CONFIG_BOOTDELAY 3
#ifdef CONFIG_LPUART
#define CONFIG_EXTRA_ENV_SETTINGS \
"bootargs=root=/dev/ram0 rw console=ttyLP0,115200\0" \
- "initrd_high=0xcfffffff\0" \
- "fdt_high=0xcfffffff\0"
+ "initrd_high=0xffffffff\0" \
+ "fdt_high=0xffffffff\0"
#else
#define CONFIG_EXTRA_ENV_SETTINGS \
"bootargs=root=/dev/ram0 rw console=ttyS0,115200\0" \
- "initrd_high=0xcfffffff\0" \
- "fdt_high=0xcfffffff\0"
+ "initrd_high=0xffffffff\0" \
+ "fdt_high=0xffffffff\0"
#endif
/*
#define CONFIG_SYS_MAXARGS 16 /* max number of command args */
#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE
-#define CONFIG_CMD_ENV_EXISTS
#define CONFIG_CMD_GREPENV
#define CONFIG_CMD_MEMINFO
#define CONFIG_CMD_MEMTEST
#define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_TEXT_BASE /* start of monitor */
#endif
-#define CONFIG_SYS_QE_FW_ADDR 0x67f40000
+#define CONFIG_SYS_QE_FW_ADDR 0x600c0000
/*
* Environment
#define CONFIG_ENV_SECT_SIZE 0x20000 /* 128K (one sector) */
#endif
-#define CONFIG_OF_LIBFDT
-#define CONFIG_OF_BOARD_SETUP
#define CONFIG_CMD_BOOTZ
#define CONFIG_MISC_INIT_R
/* Hash command with SHA acceleration supported in hardware */
+#ifdef CONFIG_FSL_CAAM
#define CONFIG_CMD_HASH
#define CONFIG_SHA_HW_ACCEL
-
-#ifdef CONFIG_SECURE_BOOT
-#define CONFIG_CMD_BLOB
#endif
+#include <asm/fsl_secure_boot.h>
+#define CONFIG_SYS_BOOTM_LEN (64 << 20) /* Increase max gunzip size */
+
#endif
projects / people / ms / u-boot.git / blobdiff