configs: Re-sync with cmd/Kconfig

[people/ms/u-boot.git] / include / configs / microblaze-generic.h

diff --git a/include/configs/microblaze-generic.h b/include/configs/microblaze-generic.h
index 45a981bf48d502b52a621ac91899a103ff45ac52..801d674610003a4f40feaa1bcd197c7db353ab68 100644 (file)
--- a/include/configs/microblaze-generic.h
+++ b/include/configs/microblaze-generic.h
@@ -40,31 +40,12 @@
 /* setting reset address */
 /*#define      CONFIG_SYS_RESET_ADDRESS        CONFIG_SYS_TEXT_BASE*/
 
-/* ethernet */
-#undef CONFIG_SYS_ENET
-#if defined(CONFIG_XILINX_EMACLITE) || defined(CONFIG_XILINX_AXIEMAC)
-# define CONFIG_SYS_ENET
-#endif
-
-#undef ET_DEBUG
-
 /* gpio */
 #ifdef XILINX_GPIO_BASEADDR
 # define CONFIG_XILINX_GPIO
 # define CONFIG_SYS_GPIO_0_ADDR                XILINX_GPIO_BASEADDR
 #endif
-
-/* interrupt controller */
-#ifdef XILINX_INTC_BASEADDR
-# define CONFIG_SYS_INTC_0_ADDR                XILINX_INTC_BASEADDR
-# define CONFIG_SYS_INTC_0_NUM         XILINX_INTC_NUM_INTR_INPUTS
-#endif
-
-/* timer */
-#if defined(XILINX_TIMER_BASEADDR) && defined(XILINX_TIMER_IRQ)
-#  define CONFIG_SYS_TIMER_0_ADDR      XILINX_TIMER_BASEADDR
-#  define CONFIG_SYS_TIMER_0_IRQ       XILINX_TIMER_IRQ
-#endif
+#define CONFIG_BOARD_LATE_INIT
 
 /* watchdog */
 #if defined(XILINX_WATCHDOG_BASEADDR) && defined(XILINX_WATCHDOG_IRQ)
@@ -76,13 +57,6 @@
 # endif
 #endif
 
-#if !defined(CONFIG_OF_CONTROL) || \
-       (defined(CONFIG_SPL_BUILD) && !defined(CONFIG_SPL_OF_CONTROL))
-/* ddr sdram - main memory */
-# define CONFIG_SYS_SDRAM_BASE XILINX_RAM_START
-# define CONFIG_SYS_SDRAM_SIZE XILINX_RAM_SIZE
-#endif
-
 #define CONFIG_SYS_MALLOC_LEN  0xC0000
 
 /* Stack location before relocation */
@@ -171,16 +145,6 @@
 #endif /* !SPIFLASH */
 #endif /* !FLASH */
 
-/* system ace */
-#ifdef XILINX_SYSACE_BASEADDR
-# define CONFIG_SYSTEMACE
-/* #define DEBUG_SYSTEMACE */
-# define SYSTEMACE_CONFIG_FPGA
-# define CONFIG_SYS_SYSTEMACE_BASE     XILINX_SYSACE_BASEADDR
-# define CONFIG_SYS_SYSTEMACE_WIDTH    XILINX_SYSACE_MEM_WIDTH
-# define CONFIG_DOS_PARTITION
-#endif
-
 #if defined(XILINX_USE_ICACHE)
 # define CONFIG_ICACHE
 #else
@@ -208,25 +172,11 @@
 /*
  * Command line configuration.
  */
-#define CONFIG_CMD_ASKENV
 #define CONFIG_CMD_IRQ
 #define CONFIG_CMD_MFSL
 
 #if defined(CONFIG_DCACHE) || defined(CONFIG_ICACHE)
-# define CONFIG_CMD_CACHE
 #else
-# undef CONFIG_CMD_CACHE
-#endif
-
-#ifdef CONFIG_SYS_ENET
-# define CONFIG_CMD_PING
-# define CONFIG_CMD_DHCP
-# define CONFIG_CMD_TFTPPUT
-#endif
-
-#if defined(CONFIG_SYSTEMACE)
-# define CONFIG_CMD_EXT2
-# define CONFIG_CMD_FAT
 #endif
 
 #if defined(FLASH)
@@ -240,7 +190,6 @@
 
 #else
 #if defined(SPIFLASH)
-# define CONFIG_CMD_SF
 
 # if !defined(RAMENV)
 #  define CONFIG_CMD_SAVES
@@ -288,7 +237,7 @@
 #define        CONFIG_SYS_MAXARGS      15
 #define        CONFIG_SYS_LONGHELP
 /* default load address */
-#define        CONFIG_SYS_LOAD_ADDR    XILINX_RAM_START
+#define        CONFIG_SYS_LOAD_ADDR    0
 
 #define        CONFIG_BOOTDELAY        -1      /* -1 disables auto-boot */
 #define        CONFIG_BOOTARGS         "root=romfs"
@@ -315,20 +264,13 @@
 
 #define CONFIG_CMDLINE_EDITING
 
-#define CONFIG_NETCONSOLE
 #define CONFIG_SYS_CONSOLE_IS_IN_ENV
 
-/* Use the HUSH parser */
-#define CONFIG_SYS_HUSH_PARSER
-
 /* Enable flat device tree support */
 #define CONFIG_LMB             1
-#define CONFIG_FIT             1
-#define CONFIG_OF_LIBFDT       1
 
 #if defined(CONFIG_XILINX_AXIEMAC)
 # define CONFIG_MII            1
-# define CONFIG_CMD_MII                1
 # define CONFIG_PHY_GIGE       1
 # define CONFIG_SYS_FAULT_ECHO_LINK_DOWN       1
 # define CONFIG_PHY_ATHEROS    1
@@ -343,7 +285,6 @@
 # define CONFIG_PHY_VITESSE    1
 #else
 # undef CONFIG_MII
-# undef CONFIG_CMD_MII
 #endif
 
 /* SPL part */