bootcount: Migrate CONFIG_SYS_BOOTCOUNT_ADDR

[people/ms/u-boot.git] / include / configs / mx6sxsabreauto.h

diff --git a/include/configs/mx6sxsabreauto.h b/include/configs/mx6sxsabreauto.h
index 448b575c2897d0664394d85b6579f710e140a94f..06e416bb59d1db18ac24b8c5ebf6b16be77aa3ea 100644 (file)
--- a/include/configs/mx6sxsabreauto.h
+++ b/include/configs/mx6sxsabreauto.h
@@ -95,8 +95,6 @@
 #define CONFIG_SYS_MEMTEST_START       0x80000000
 #define CONFIG_SYS_MEMTEST_END         (CONFIG_SYS_MEMTEST_START + 0x10000)
 
-#define CONFIG_STACKSIZE               SZ_128K
-
 /* Physical Memory Map */
 #define CONFIG_NR_DRAM_BANKS           1
 #define PHYS_SDRAM                     MMDC0_ARB_BASE_ADDR
@@ -120,21 +118,13 @@
 #define CONFIG_SYS_I2C_MXC_I2C3                /* enable I2C bus 3 */
 #define CONFIG_SYS_I2C_SPEED             100000
 
-/* NAND flash command */
-#define CONFIG_CMD_NAND
-#define CONFIG_CMD_NAND_TRIMFFS
-
 /* NAND stuff */
-#define CONFIG_NAND_MXS
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
 #define CONFIG_SYS_NAND_BASE           0x40000000
 #define CONFIG_SYS_NAND_5_ADDR_CYCLE
 #define CONFIG_SYS_NAND_ONFI_DETECTION
 
 /* DMA stuff, needed for GPMI/MXS NAND support */
-#define CONFIG_APBH_DMA
-#define CONFIG_APBH_DMA_BURST
-#define CONFIG_APBH_DMA_BURST8
 
 /* Network */
 
@@ -147,15 +137,10 @@
 #define CONFIG_FEC_XCV_TYPE             RGMII
 #define CONFIG_ETHPRIME                 "FEC"
 
-#define CONFIG_PHYLIB
 #define CONFIG_PHY_ATHEROS
 
 #ifdef CONFIG_CMD_USB
-#define CONFIG_USB_EHCI
-#define CONFIG_USB_EHCI_MX6
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
-#define CONFIG_USB_HOST_ETHER
-#define CONFIG_USB_ETHER_ASIX
 #define CONFIG_MXC_USB_PORTSC  (PORT_PTS_UTMI | PORT_PTS_PTW)
 #define CONFIG_MXC_USB_FLAGS   0
 #define CONFIG_USB_MAX_CONTROLLER_COUNT 2
@@ -175,7 +160,6 @@
 
 #define CONFIG_ENV_OFFSET              (8 * SZ_64K)
 #define CONFIG_ENV_SIZE                        SZ_8K
-#define CONFIG_ENV_IS_IN_MMC
 
 #define CONFIG_SYS_FSL_USDHC_NUM       2
 #if defined(CONFIG_ENV_IS_IN_MMC)