Convert CONFIG_CMD_EEPROM et al to Kconfig

[people/ms/u-boot.git] / include / configs / p1_p2_rdb_pc.h

diff --git a/include/configs/p1_p2_rdb_pc.h b/include/configs/p1_p2_rdb_pc.h
index f91a7628d86f4d34e8d8fc95ca327902ae80bf01..24f751c8392f35ff1ab14e671da11999ee08b9b4 100644 (file)
--- a/include/configs/p1_p2_rdb_pc.h
+++ b/include/configs/p1_p2_rdb_pc.h
@@ -260,7 +260,6 @@
 
 #define CONFIG_MP
 
-#define CONFIG_FSL_ELBC
 #define CONFIG_PCIE1   /* PCIE controller 1 (slot 1) */
 #define CONFIG_PCIE2   /* PCIE controller 2 (slot 2) */
 #define CONFIG_FSL_PCI_INIT    /* Use common FSL init code */
@@ -291,8 +290,6 @@
 #define CONFIG_L2_CACHE
 #define CONFIG_BTB
 
-#define CONFIG_BOARD_EARLY_INIT_F      /* Call board_pre_init */
-
 #define CONFIG_ENABLE_36BIT_PHYS
 
 #ifdef CONFIG_PHYS_64BIT
@@ -634,7 +631,6 @@
 #define CONFIG_SYS_I2C_PCA9557_ADDR    0x18
 
 /* enable read and write access to EEPROM */
-#define CONFIG_CMD_EEPROM
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -698,7 +694,6 @@
 #define CONFIG_CMD_PCI
 
 #define CONFIG_PCI_SCAN_SHOW   /* show pci devices on startup */
-#define CONFIG_DOS_PARTITION
 #endif /* CONFIG_PCI */
 
 #if defined(CONFIG_TSEC_ENET)
@@ -819,7 +814,6 @@
  * Command line configuration.
  */
 #define CONFIG_CMD_IRQ
-#define CONFIG_CMD_DATE
 #define CONFIG_CMD_REGINFO
 
 /*
@@ -828,9 +822,7 @@
 #define CONFIG_HAS_FSL_DR_USB
 
 #if defined(CONFIG_HAS_FSL_DR_USB)
-#define CONFIG_USB_EHCI
-
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #endif
@@ -843,12 +835,6 @@
 #ifdef CONFIG_MMC
 #define CONFIG_FSL_ESDHC
 #define CONFIG_SYS_FSL_ESDHC_ADDR      CONFIG_SYS_MPC85xx_ESDHC_ADDR
-#define CONFIG_GENERIC_MMC
-#endif
-
-#if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI) \
-                || defined(CONFIG_FSL_SATA)
-#define CONFIG_DOS_PARTITION
 #endif
 
 #undef CONFIG_WATCHDOG /* watchdog disabled */
@@ -894,8 +880,6 @@
 
 #define CONFIG_BOOTARGS        /* the boot command will set bootargs */
 
-#define CONFIG_BAUDRATE        115200
-
 #ifdef __SW_BOOT_NOR
 #define __NOR_RST_CMD  \
 norboot=i2c dev 1; i2c mw 18 1 __SW_BOOT_NOR 1; \