drivers/pci/Kconfig: Add PCI

[people/ms/u-boot.git] / include / configs / qemu-ppce500.h

diff --git a/include/configs/qemu-ppce500.h b/include/configs/qemu-ppce500.h
index 293684e4d60d35f812343e7d4330a75b60d09779..2c9a4aa39d94fb85f35b9fd05ed0f6ebba3e0a70 100644 (file)
--- a/include/configs/qemu-ppce500.h
+++ b/include/configs/qemu-ppce500.h
@@ -24,7 +24,6 @@
 
 #define CONFIG_SYS_RAMBOOT
 
-#define CONFIG_PCI                     /* Enable PCI/PCIE */
 #define CONFIG_PCI1            1       /* PCI controller 1 */
 #define CONFIG_FSL_PCI_INIT            /* Use common FSL init code */
 #define CONFIG_SYS_PCI_64BIT           /* enable 64-bit PCI resources */
@@ -56,8 +55,6 @@ extern unsigned long long get_phys_ccsrbar_addr_early(void);
 #define CONFIG_SYS_CCSRBAR_PHYS_LOW CONFIG_SYS_CCSRBAR
 #endif
 
-#define CONFIG_PHYS_64BIT
-
 /* Virtual address range for PCI region maps */
 #define CONFIG_SYS_PCI_MAP_START       0x80000000
 #define CONFIG_SYS_PCI_MAP_END         0xe8000000
@@ -113,10 +110,6 @@ extern unsigned long long get_phys_ccsrbar_addr_early(void);
 #define CONFIG_SYS_NS16550_COM1        (CONFIG_SYS_CCSRBAR+0x4500)
 #define CONFIG_SYS_NS16550_COM2        (CONFIG_SYS_CCSRBAR+0x4600)
 
-/* Use the HUSH parser */
-#define CONFIG_SYS_HUSH_PARSER
-#define CONFIG_SYS_PROMPT_HUSH_PS2 "> "
-
 /*
  * General PCI
  * Memory space is mapped 1-1, but I/O space must start from 0.
@@ -132,7 +125,6 @@ extern unsigned long long get_phys_ccsrbar_addr_early(void);
 
 #define CONFIG_LBA48
 #define CONFIG_DOS_PARTITION
-#define CONFIG_CMD_EXT2
 
 /*
  * Environment
@@ -146,11 +138,7 @@ extern unsigned long long get_phys_ccsrbar_addr_early(void);
 /*
  * Command line configuration.
  */
-#define CONFIG_CMD_DHCP
-#define CONFIG_CMD_BOOTZ
-#define CONFIG_CMD_GREPENV
 #define CONFIG_CMD_IRQ
-#define CONFIG_CMD_PING
 
 #ifdef CONFIG_PCI
 #define CONFIG_CMD_PCI
@@ -188,7 +176,6 @@ extern unsigned long long get_phys_ccsrbar_addr_early(void);
 
 #define CONFIG_BAUDRATE        115200
 
-#define CONFIG_BOOTDELAY        1
 #define CONFIG_BOOTCOMMAND             \
        "test -n \"$qemu_kernel_addr\" && bootm $qemu_kernel_addr - $fdt_addr_r\0"