#endif
/* Network Configuration */
-#define CONFIG_PHYLIB
#define CONFIG_PHY_MARVELL
#define CONFIG_MII
#define CONFIG_BOOTP_DEFAULT
#define CONFIG_SYS_DAVINCI_I2C_SLAVE1 0x10 /* SMBus host address */
#define CONFIG_SYS_DAVINCI_I2C_SPEED2 100000
#define CONFIG_SYS_DAVINCI_I2C_SLAVE2 0x10 /* SMBus host address */
-#define I2C_BUS_MAX 3
/* EEPROM definitions */
#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 2
#define CONFIG_SYS_MAX_NAND_DEVICE 1
#define CONFIG_SYS_NAND_MAX_CHIPS 1
#define CONFIG_SYS_NAND_NO_SUBPAGE_WRITE
-#define CONFIG_ENV_SIZE (256 << 10) /* 256 KiB */
-#define CONFIG_ENV_IS_IN_NAND
-#define CONFIG_ENV_OFFSET 0x100000
#define CONFIG_MTD_PARTITIONS
-#define CONFIG_RBTREE
-#define CONFIG_LZO
#define MTDIDS_DEFAULT "nand0=davinci_nand.0"
#define MTDPARTS_DEFAULT "mtdparts=davinci_nand.0:" \
"1024k(bootloader)ro,512k(params)ro," \
/* USB Configuration */
#define CONFIG_USB_XHCI_KEYSTONE
-#define CONFIG_SYS_USB_XHCI_MAX_ROOT_PORTS 2
-#define CONFIG_FS_FAT
#define CONFIG_USB_SS_BASE KS2_USB_SS_BASE
#define CONFIG_USB_HOST_XHCI_BASE KS2_USB_HOST_XHCI_BASE
#define CONFIG_DEV_USB_PHY_BASE KS2_DEV_USB_PHY_BASE
#define CONFIG_USB_PHY_CFG_BASE KS2_USB_PHY_CFG_BASE
-/* U-Boot command configuration */
-#define CONFIG_CMD_SAVES
-#define CONFIG_CMD_UBIFS
-#define CONFIG_CMD_EEPROM
-
/* U-Boot general configuration */
#define CONFIG_MISC_INIT_R
-#define CONFIG_CRC32_VERIFY
#define CONFIG_MX_CYCLIC
#define CONFIG_TIMESTAMP
/* EDMA3 */
#define CONFIG_TI_EDMA3
+#define KERNEL_MTD_PARTS \
+ "mtdparts=" \
+ SPI_MTD_PARTS
+
#define DEFAULT_FW_INITRAMFS_BOOT_ENV \
"name_fw_rd=k2-fw-initrd.cpio.gz\0" \
"set_rd_spec=setenv rd_spec ${rdaddr}:${filesize}\0" \
"addr_secdb_key=0xc000000\0" \
"name_kern=zImage\0" \
"addr_mon=0x87000000\0" \
+ "addr_non_sec_mon=0x0c087fc0\0" \
+ "addr_load_sec_bm=0x0c08c000\0" \
"run_mon=mon_install ${addr_mon}\0" \
+ "run_mon_hs=mon_install ${addr_non_sec_mon} " \
+ "${addr_load_sec_bm}\0" \
"run_kern=bootz ${loadaddr} ${rd_spec} ${fdtaddr}\0" \
"init_net=run args_all args_net\0" \
"init_nfs=setenv autoload no; dhcp; run args_all args_net\0" \
"get_kern_ubi=ubifsload ${loadaddr} ${bootdir}/${name_kern}\0" \
"get_mon_net=dhcp ${addr_mon} ${tftp_root}/${name_mon}\0" \
"get_mon_nfs=nfs ${addr_mon} ${nfs_root}/boot/${name_mon}\0" \
- "get_mon_ubi=ubifsload ${addr_mon} ${bootdir}/${name_mon}\0" \
+ "get_mon_ubi=ubifsload ${addr_mon} ${bootdir}/${name_mon}\0" \
+ "get_fit_net=dhcp ${fit_loadaddr} ${tftp_root}" \
+ "/${fit_bootfile}\0" \
+ "get_fit_nfs=nfs ${fit_loadaddr} ${nfs_root}/boot/${fit_bootfile}\0"\
+ "get_fit_ubi=ubifsload ${fit_loadaddr} ${bootdir}/${fit_bootfile}\0"\
+ "get_fit_mmc=load mmc ${bootpart} ${fit_loadaddr} " \
+ "${bootdir}/${fit_bootfile}\0" \
"get_uboot_net=dhcp ${loadaddr} ${tftp_root}/${name_uboot}\0" \
"get_uboot_nfs=nfs ${loadaddr} ${nfs_root}/boot/${name_uboot}\0" \
"burn_uboot_spi=sf probe; sf erase 0 0x80000; " \
"sf write ${loadaddr} 0 ${filesize}\0" \
"burn_uboot_nand=nand erase 0 0x100000; " \
"nand write ${loadaddr} 0 ${filesize}\0" \
- "args_all=setenv bootargs console=ttyS0,115200n8 rootwait=1\0" \
+ "args_all=setenv bootargs console=ttyS0,115200n8 rootwait=1 " \
+ KERNEL_MTD_PARTS \
"args_net=setenv bootargs ${bootargs} rootfstype=nfs " \
"root=/dev/nfs rw nfsroot=${serverip}:${nfs_root}," \
"${nfs_options} ip=dhcp\0" \
"get_fdt_ramfs=dhcp ${fdtaddr} ${tftp_root}/${name_fdt}\0" \
"get_kern_ramfs=dhcp ${loadaddr} ${tftp_root}/${name_kern}\0" \
"get_mon_ramfs=dhcp ${addr_mon} ${tftp_root}/${name_mon}\0" \
+ "get_fit_ramfs=dhcp ${fit_loadaddr} ${tftp_root}" \
+ "/${fit_bootfile}\0" \
"get_fs_ramfs=dhcp ${rdaddr} ${tftp_root}/${name_fs}\0" \
"get_ubi_net=dhcp ${addr_ubi} ${tftp_root}/${name_ubi}\0" \
"get_ubi_nfs=nfs ${addr_ubi} ${nfs_root}/boot/${name_ubi}\0" \
"1024k(bootloader)ro,512k(params)ro,-(ubifs)\0"
#ifndef CONFIG_BOOTCOMMAND
+#ifndef CONFIG_TI_SECURE_DEVICE
+#define CONFIG_BOOTCOMMAND \
+ "run init_${boot}; " \
+ "run get_mon_${boot} run_mon; " \
+ "run get_kern_${boot}; " \
+ "run init_fw_rd_${boot}; " \
+ "run get_fdt_${boot}; " \
+ "run run_kern"
+#else
#define CONFIG_BOOTCOMMAND \
- "run init_${boot} get_mon_${boot} run_mon init_fw_rd_${boot} " \
- "get_fdt_${boot} get_kern_${boot} run_kern"
+ "run run_mon_hs; " \
+ "run init_${boot}; " \
+ "run get_fit_${boot}; " \
+ "bootm ${fit_loadaddr}#${name_fdt}"
+#endif
#endif
-
-#define CONFIG_BOOTARGS \
/* Now for the remaining common defines */
#include <configs/ti_armv7_common.h>
#ifndef CONFIG_SOC_K2G
#define CONFIG_SYS_HZ_CLOCK ks_clk_get_rate(KS2_CLK1_6)
#else
-#define CONFIG_SYS_HZ_CLOCK external_clk[sys_clk]
+#define CONFIG_SYS_HZ_CLOCK get_external_clk(sys_clk)
#endif
#endif /* __CONFIG_KS2_EVM_H */
projects / people / ms / u-boot.git / blobdiff