#ifndef __CONFIG_UNIPHIER_COMMON_H__
#define __CONFIG_UNIPHIER_COMMON_H__
-#if defined(CONFIG_MACH_PH1_PRO4)
-#define CONFIG_DDR_NUM_CH0 2
-#define CONFIG_DDR_NUM_CH1 2
-
-/* Physical start address of SDRAM */
-#define CONFIG_SDRAM0_BASE 0x80000000
-#define CONFIG_SDRAM0_SIZE 0x20000000
-#define CONFIG_SDRAM1_BASE 0xa0000000
-#define CONFIG_SDRAM1_SIZE 0x20000000
-#endif
-
-#if defined(CONFIG_MACH_PH1_LD4)
-#define CONFIG_DDR_NUM_CH0 1
-#define CONFIG_DDR_NUM_CH1 1
-
-/* Physical start address of SDRAM */
-#define CONFIG_SDRAM0_BASE 0x80000000
-#define CONFIG_SDRAM0_SIZE 0x10000000
-#define CONFIG_SDRAM1_BASE 0x90000000
-#define CONFIG_SDRAM1_SIZE 0x10000000
-#endif
-
-#if defined(CONFIG_MACH_PH1_SLD8)
-#define CONFIG_DDR_NUM_CH0 1
-#define CONFIG_DDR_NUM_CH1 1
-
-/* Physical start address of SDRAM */
-#define CONFIG_SDRAM0_BASE 0x80000000
-#define CONFIG_SDRAM0_SIZE 0x10000000
-#define CONFIG_SDRAM1_BASE 0x90000000
-#define CONFIG_SDRAM1_SIZE 0x10000000
-#endif
-
#define CONFIG_I2C_EEPROM
#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 10
-/*
- * Support card address map
- */
-#if defined(CONFIG_PFC_MICRO_SUPPORT_CARD)
-# define CONFIG_SUPPORT_CARD_BASE 0x03f00000
-# define CONFIG_SUPPORT_CARD_ETHER_BASE (CONFIG_SUPPORT_CARD_BASE + 0x00000000)
-# define CONFIG_SUPPORT_CARD_LED_BASE (CONFIG_SUPPORT_CARD_BASE + 0x00090000)
-# define CONFIG_SUPPORT_CARD_UART_BASE (CONFIG_SUPPORT_CARD_BASE + 0x000b0000)
-#endif
-
-#if defined(CONFIG_DCC_MICRO_SUPPORT_CARD)
-# define CONFIG_SUPPORT_CARD_BASE 0x08000000
-# define CONFIG_SUPPORT_CARD_ETHER_BASE (CONFIG_SUPPORT_CARD_BASE + 0x00000000)
-# define CONFIG_SUPPORT_CARD_LED_BASE (CONFIG_SUPPORT_CARD_BASE + 0x00401630)
-# define CONFIG_SUPPORT_CARD_UART_BASE (CONFIG_SUPPORT_CARD_BASE + 0x00200000)
-#endif
-
#ifdef CONFIG_SYS_NS16550_SERIAL
-#define CONFIG_SYS_NS16550
#define CONFIG_SYS_NS16550_COM1 CONFIG_SUPPORT_CARD_UART_BASE
#define CONFIG_SYS_NS16550_CLK 12288000
#define CONFIG_SYS_NS16550_REG_SIZE -2
#define CONFIG_SMC911X
-#define CONFIG_SMC911X_BASE CONFIG_SUPPORT_CARD_ETHER_BASE
+/* dummy: referenced by examples/standalone/smc911x_eeprom.c */
+#define CONFIG_SMC911X_BASE 0
#define CONFIG_SMC911X_32_BIT
/*-----------------------------------------------------------------------
#define CONFIG_FLASH_SHOW_PROGRESS 45 /* count down from 45/5: 9..1 */
-#define CONFIG_SYS_MAX_FLASH_BANKS_DETECT 2
+#define CONFIG_SYS_MAX_FLASH_BANKS_DETECT 1
/* serial console configuration */
#define CONFIG_BAUDRATE 115200
-#define CONFIG_SYS_GENERIC_BOARD
#if !defined(CONFIG_SPL_BUILD)
#define CONFIG_USE_ARCH_MEMSET
#define CONFIG_NAND_DENALI_ECC_SIZE 1024
+#ifdef CONFIG_ARCH_UNIPHIER_PH1_SLD3
+#define CONFIG_SYS_NAND_REGS_BASE 0xf8100000
+#define CONFIG_SYS_NAND_DATA_BASE 0xf8000000
+#else
#define CONFIG_SYS_NAND_REGS_BASE 0x68100000
#define CONFIG_SYS_NAND_DATA_BASE 0x68000000
+#endif
#define CONFIG_SYS_NAND_BASE (CONFIG_SYS_NAND_DATA_BASE + 0x10)
#define CONFIG_BOOTDELAY 3
#define CONFIG_ZERO_BOOTDELAY_CHECK /* check for keypress on bootdelay==0 */
-#define CONFIG_AUTOBOOT_KEYED 1
-#define CONFIG_AUTOBOOT_PROMPT \
- "Press SPACE to abort autoboot in %d seconds\n", bootdelay
-#define CONFIG_AUTOBOOT_DELAY_STR "d"
-#define CONFIG_AUTOBOOT_STOP_STR " "
/*
* Network Configuration
#define CONFIG_LOADADDR 0x84000000
#define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR
-#define CONFIG_BOOTFILE "fit.itb"
#define CONFIG_CMDLINE_EDITING /* add command line history */
"ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname:$netdev:off;" \
"tftpboot; bootm;"
-#define CONFIG_BOOTARGS " user_debug=0x1f init=/sbin/init"
-
-#define CONFIG_EXTRA_ENV_SETTINGS \
- "netdev=eth0\0" \
- "image_offset=0x00080000\0" \
- "image_size=0x00f00000\0" \
- "verify=n\0" \
- "nandupdate=nand erase 0 0x100000 &&" \
- "tftpboot u-boot-spl.bin &&" \
- "nand write $loadaddr 0 0x10000 &&" \
- "tftpboot u-boot-dtb.img &&" \
- "nand write $loadaddr 0x10000 0xf0000\0" \
- "norboot=run add_default_bootargs &&" \
- "bootm $image_offset\0" \
- "nandboot=run add_default_bootargs &&" \
- "nand read $loadaddr $image_offset $image_size &&" \
- "bootm\0" \
- "add_default_bootargs=setenv bootargs $bootargs" \
- " console=ttyS0,$baudrate\0" \
+#ifdef CONFIG_FIT
+#define CONFIG_BOOTFILE "fitImage"
+#define LINUXBOOT_ENV_SETTINGS \
+ "fit_addr=0x00100000\0" \
+ "fit_addr_r=0x84100000\0" \
+ "fit_size=0x00f00000\0" \
+ "norboot=setexpr fit_addr $nor_base + $fit_addr &&" \
+ "bootm $fit_addr\0" \
+ "nandboot=nand read $fit_addr_r $fit_addr $fit_size &&" \
+ "bootm $fit_addr_r\0" \
+ "tftpboot=tftpboot $fit_addr_r $bootfile &&" \
+ "bootm $fit_addr_r\0"
+#else
+#define CONFIG_BOOTFILE "uImage"
+#define LINUXBOOT_ENV_SETTINGS \
+ "fdt_addr=0x00100000\0" \
+ "fdt_addr_r=0x84100000\0" \
+ "fdt_size=0x00008000\0" \
+ "fdt_file=" CONFIG_DEFAULT_DEVICE_TREE ".dtb\0" \
+ "kernel_addr=0x00200000\0" \
+ "kernel_addr_r=0x84200000\0" \
+ "kernel_size=0x00800000\0" \
+ "ramdisk_addr=0x00a00000\0" \
+ "ramdisk_addr_r=0x84a00000\0" \
+ "ramdisk_size=0x00600000\0" \
+ "ramdisk_file=rootfs.cpio.uboot\0" \
+ "norboot=setexpr kernel_addr $nor_base + $kernel_addr &&" \
+ "setexpr ramdisk_addr $nor_base + $ramdisk_addr &&" \
+ "setexpr fdt_addr $nor_base + $fdt_addr &&" \
+ "bootm $kernel_addr $ramdisk_addr $fdt_addr\0" \
+ "nandboot=nand read $kernel_addr_r $kernel_addr $kernel_size &&" \
+ "nand read $ramdisk_addr_r $ramdisk_addr $ramdisk_size &&" \
+ "nand read $fdt_addr_r $fdt_addr $fdt_size &&" \
+ "bootm $kernel_addr_r $ramdisk_addr_r $fdt_addr_r\0" \
+ "tftpboot=tftpboot $kernel_addr_r $bootfile &&" \
+ "tftpboot $ramdisk_addr_r $ramdisk_file &&" \
+ "tftpboot $fdt_addr_r $fdt_file &&" \
+ "bootm $kernel_addr_r $ramdisk_addr_r $fdt_addr_r\0"
+#endif
+
+#define CONFIG_EXTRA_ENV_SETTINGS \
+ "netdev=eth0\0" \
+ "verify=n\0" \
+ "norbase=0x42000000\0" \
+ "nandupdate=nand erase 0 0x00100000 &&" \
+ "tftpboot u-boot-spl-dtb.bin &&" \
+ "nand write $loadaddr 0 0x00010000 &&" \
+ "tftpboot u-boot-dtb.img &&" \
+ "nand write $loadaddr 0x00010000 0x000f0000\0" \
+ LINUXBOOT_ENV_SETTINGS
/* Open Firmware flat tree */
#define CONFIG_OF_LIBFDT
-#define CONFIG_LIB_RAND
-
-#define CONFIG_HAVE_ARM_SECURE
-
-/* Memory Size & Mapping */
-#define CONFIG_SYS_SDRAM_BASE CONFIG_SDRAM0_BASE
-
-#if CONFIG_SDRAM0_BASE + CONFIG_SDRAM0_SIZE >= CONFIG_SDRAM1_BASE
-/* Thre is no memory hole */
-#define CONFIG_NR_DRAM_BANKS 1
-#define CONFIG_SYS_SDRAM_SIZE (CONFIG_SDRAM0_SIZE + CONFIG_SDRAM1_SIZE)
-#else
+#define CONFIG_SYS_SDRAM_BASE 0x80000000
#define CONFIG_NR_DRAM_BANKS 2
-#define CONFIG_SYS_SDRAM_SIZE (CONFIG_SDRAM0_SIZE)
-#endif
-#if defined(CONFIG_MACH_PH1_LD4) || defined(CONFIG_MACH_PH1_SLD8)
+#if defined(CONFIG_ARCH_UNIPHIER_PH1_SLD3) || \
+ defined(CONFIG_ARCH_UNIPHIER_PH1_LD4) || \
+ defined(CONFIG_ARCH_UNIPHIER_PH1_SLD8)
#define CONFIG_SPL_TEXT_BASE 0x00040000
-#endif
-#if defined(CONFIG_MACH_PH1_PRO4)
+#else
#define CONFIG_SPL_TEXT_BASE 0x00100000
#endif
projects / people / ms / u-boot.git / blobdiff