From e46f8a3309fb2628940d3e2806c954d84f910165 Mon Sep 17 00:00:00 2001 From: Lukasz Majewski Date: Tue, 21 Mar 2017 12:08:25 +0100 Subject: [PATCH] i2c: Set default I2C bus number This patch allows using i2c commands (e.g. "i2c probe", "i2c md", etc) without the need to first select the bus number with e.g. "i2c dev 0". This is the "i2c" command behavior similar to the one from pre DM, where by default bus 0 was immediately accessible. Signed-off-by: Lukasz Majewski --- cmd/i2c.c | 10 ++++++++++ drivers/i2c/Kconfig | 14 ++++++++++++++ 2 files changed, 24 insertions(+) diff --git a/cmd/i2c.c b/cmd/i2c.c index 473153fbd4..3dd7c6ba4d 100644 --- a/cmd/i2c.c +++ b/cmd/i2c.c @@ -151,6 +151,16 @@ static int cmd_i2c_set_bus_num(unsigned int busnum) static int i2c_get_cur_bus(struct udevice **busp) { +#ifdef CONFIG_I2C_SET_DEFAULT_BUS_NUM + if (!i2c_cur_bus) { + if (cmd_i2c_set_bus_num(CONFIG_I2C_DEFAULT_BUS_NUMBER)) { + printf("Default I2C bus %d not found\n", + CONFIG_I2C_DEFAULT_BUS_NUMBER); + return -ENODEV; + } + } +#endif + if (!i2c_cur_bus) { puts("No I2C bus selected\n"); return -ENODEV; diff --git a/drivers/i2c/Kconfig b/drivers/i2c/Kconfig index 8ac7aaf2d2..4e9afc120a 100644 --- a/drivers/i2c/Kconfig +++ b/drivers/i2c/Kconfig @@ -49,6 +49,20 @@ config I2C_CROS_EC_LDO avoid duplicating the logic in the TPS65090 regulator driver for enabling/disabling an LDO. +config I2C_SET_DEFAULT_BUS_NUM + bool "Set default I2C bus number" + depends on DM_I2C + help + Set default number of I2C bus to be accessed. This option provides + behaviour similar to old (i.e. pre DM) I2C bus driver. + +config I2C_DEFAULT_BUS_NUMBER + hex "I2C default bus number" + depends on I2C_SET_DEFAULT_BUS_NUM + default 0x0 + help + Number of default I2C bus to use + config DM_I2C_GPIO bool "Enable Driver Model for software emulated I2C bus driver" depends on DM_I2C && DM_GPIO -- 2.39.2