case "$1" in
start)
+ if [ ! -e /etc/sysconfig/lm_sensors ]; then
+ boot_mesg "Searching for Sensors..."
+ "yes" | /usr/sbin/sensors-detect > /dev/null
+ evaluate_retval
+ if [ ! -e /etc/sysconfig/lm_sensors ]; then
+ echo "#No Sensors detected " > /etc/sysconfig/lm_sensors
+ fi
+ fi
+
+ boot_mesg -n "Loading Sensor Modules..."
+ for modul in `cat /etc/sysconfig/lm_sensors | grep '^MODULE_' | cut -d"=" -s -f2`; do
+ modprobe $modul > /dev/null 2>&1;
+ if [ ${?} = 0 ]; then
+ boot_mesg -n "$SUCCESS$modul$NORMAL ";
+ else
+ boot_mesg -n "$FAILURE$modul$NORMAL ";
+ fi
+ done
+ boot_mesg;
+ echo_ok;
+
boot_mesg "Starting Collection daemon..."
/usr/sbin/collectd -C /etc/collectd.conf
evaluate_retval
+#
+# These lines are for furhter implementation of the collectd, atm the temps are
+# collected by the makegraphs script because of the standby functions
+#
# for disk in `kudzu -qps -c HD | grep device: | cut -d" " -f2 | sort | uniq`; do boot_mesg "Bringing up hddtemp daemon for $disk ..."; /usr/sbin/hddtemp $disk -d -l localhost; evaluate_retval; done
+#
+# Starting the mbmon in deamon mode to enable sensors reading for collectd
+# later mbmon will be replaced by lmsensors, if mbmon is not running on your
+# system, we advise to comment out these lines in order to prevent fail
+#
# boot_mesg "Bringing up mbmon daemon..."
# /usr/bin/mbmon -P 411 -r
# evaluate_retval
;;
stop)
+# if mbmon is not running on your system, we advise to comment out these lines
+# in order to prevent fail
# boot_mesg "Stopping mbmon daemon..."
# killproc /usr/bin/mbmon
# evaluate_retval
;;
restart)
- $0 stop
+
+#
+# We need to do this that way because mbmon doesn`t clear the port when killed
+# so the next startup it fails with port allready in use -> donĀ“t restart mbmon
+#
+ boot_mesg "Stopping Collection daemon..."
+ killproc /usr/sbin/collectd
+ evaluate_retval
sleep 1
- $0 start
+ boot_mesg "Starting Collection daemon..."
+ /usr/sbin/collectd -C /etc/collectd.conf
evaluate_retval
;;