Bluetooth: hci_h5: avoid sending two SYNC messages

Bluetooth: hci_h5: avoid sending two SYNC messages

Previously, h5_open() called h5_link_control() to send a SYNC message.
But h5_link_control() only enqueues the packet and requires the caller
to call hci_uart_tx_wakeup(). Thus, after H5_SYNC_TIMEOUT ran out
(100ms), h5_timed_event() would be called and, realizing that the state
was still H5_UNINITIALIZED, it would re-enqueue the SYNC and call
hci_uart_tx_wakeup(). Consequently, two SYNC packets would be sent and
initialization would unnecessarily wait for 100ms.

The naive solution of calling hci_uart_tx_wakeup() in h5_open() does not
work because it will only schedule tx work if the HCI_PROTO_READY bit is
set and hci_serdev only sets it after h5_open() returns. This patch
removes the extraneous SYNC being enqueued and makes h5_timed_event()
wake up on the next jiffy.

Signed-off-by: Javier Nieto <jgnieto@cs.stanford.edu>
Signed-off-by: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>