printk: Allow to use the printk kthread immediately even for 1st nbcon

printk: Allow to use the printk kthread immediately even for 1st nbcon

The kthreads for nbcon consoles are created by nbcon_alloc() at
the beginning of the console registration. But it currently works
only for the 2nd or later nbcon console because the code checks
@printk_kthreads_running.

The kthread for the 1st registered nbcon console is created at the very
end of register_console() by printk_kthreads_check_locked(). As a result,
the entire log is replayed synchronously when the "enabled" message
gets printed. It might block the boot for a long time with a slow serial
console.

Prevent the synchronous flush by creating the kthread even for the 1st
nbcon console when it is safe (kthreads ready and no boot consoles).

Also inform printk() to use the kthread by setting
@printk_kthreads_running. Note that the kthreads already must be
running when it is safe and this is not the 1st nbcon console.

Symmetrically, clear @printk_kthreads_running when the last nbcon
console was unregistered by nbcon_free(). This requires updating
@have_nbcon_console before nbcon_free() gets called.

Note that there is _no_ problem when the 1st nbcon console replaces boot
consoles. In this case, the kthread will be started at the end
of registration after the boot consoles are removed. But the console
does not reply the entire log buffer in this case. Note that
the flag CON_PRINTBUFFER is always cleared when the boot consoles are
removed and vice versa.

Closes: https://lore.kernel.org/r/20250514173514.2117832-1-mcobb@thegoodpenguin.co.uk
Tested-by: Michael Cobb <mcobb@thegoodpenguin.co.uk>
Reviewed-by: John Ogness <john.ogness@linutronix.de>
Link: https://patch.msgid.link/20250604142045.253301-1-pmladek@suse.com
Signed-off-by: Petr Mladek <pmladek@suse.com>