ARM: dts: meson: fix PHY deassert timing requirements

[ Upstream commit 656ab1bdcd2b755dc161a9774201100d5bf74b8d ]

According to the datasheet (Rev. 1.9) the RTL8211F requires at least
72ms "for internal circuits settling time" before accessing the PHY
registers. On similar boards with the same PHY this fixes an issue where
Ethernet link would not come up when using ip link set down/up.

Fixes: a2c6e82e5341 ("ARM: dts: meson: switch to the generic Ethernet PHY reset bindings")
Reviewed-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Tested-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> # on Odroid-C1+
Signed-off-by: Stefan Agner <stefan@agner.ch>
Signed-off-by: Kevin Hilman <khilman@baylibre.com>
Link: https://lore.kernel.org/r/ff78772b306411e145769c46d4090554344db41e.1607363522.git.stefan@agner.ch
Signed-off-by: Sasha Levin <sashal@kernel.org>

diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts
index a24eccc354b95851f1b48663776a26e5e74a9712..0f9c71137bed5b324a23b0f87a3600ee38ce85c3 100644 (file)
--- a/arch/arm/boot/dts/meson8b-odroidc1.dts
+++ b/arch/arm/boot/dts/meson8b-odroidc1.dts
@@ -219,7 +219,7 @@
                        reg = <0>;
 
                        reset-assert-us = <10000>;
-                       reset-deassert-us = <30000>;
+                       reset-deassert-us = <80000>;
                        reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
 
                        interrupt-parent = <&gpio_intc>;

diff --git a/arch/arm/boot/dts/meson8m2-mxiii-plus.dts b/arch/arm/boot/dts/meson8m2-mxiii-plus.dts
index d54477b1001ca775a2137060870b9cface45ece6..84b6ed51099dbeee2634ce0e16fd4eb8449ba615 100644 (file)
--- a/arch/arm/boot/dts/meson8m2-mxiii-plus.dts
+++ b/arch/arm/boot/dts/meson8m2-mxiii-plus.dts
@@ -83,7 +83,7 @@
                        reg = <0>;
 
                        reset-assert-us = <10000>;
-                       reset-deassert-us = <30000>;
+                       reset-deassert-us = <80000>;
                        reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
                };
        };