pinctrl: meson: define the pull up/down resistor value as 60 kOhm

[ Upstream commit e56088a13708757da68ad035269d69b93ac8c389 ]

The public datasheets of the following Amlogic SoCs describe a typical
resistor value for the built-in pull up/down resistor:
- Meson8/8b/8m2: not documented
- GXBB (S905): 60 kOhm
- GXL (S905X): 60 kOhm
- GXM (S912): 60 kOhm
- G12B (S922X): 60 kOhm
- SM1 (S905D3): 60 kOhm

The public G12B and SM1 datasheets additionally state min and max
values:
- min value: 50 kOhm for both, pull-up and pull-down
- max value for the pull-up: 70 kOhm
- max value for the pull-down: 130 kOhm

Use 60 kOhm in the pinctrl-meson driver as well so it's shown in the
debugfs output. It may not be accurate for Meson8/8b/8m2 but in reality
60 kOhm is closer to the actual value than 1 Ohm.

Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Reviewed-by: Neil Armstrong <neil.armstrong@linaro.org>
Link: https://lore.kernel.org/20250329190132.855196-1-martin.blumenstingl@googlemail.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>

diff --git a/drivers/pinctrl/meson/pinctrl-meson.c b/drivers/pinctrl/meson/pinctrl-meson.c
index 49851444a6e3b0bbbcc8f1e345738d7c7dffceac..d239ad85a510d1c48dd6a700f456d281319f4342 100644 (file)
--- a/drivers/pinctrl/meson/pinctrl-meson.c
+++ b/drivers/pinctrl/meson/pinctrl-meson.c
@@ -486,7 +486,7 @@ static int meson_pinconf_get(struct pinctrl_dev *pcdev, unsigned int pin,
        case PIN_CONFIG_BIAS_PULL_DOWN:
        case PIN_CONFIG_BIAS_PULL_UP:
                if (meson_pinconf_get_pull(pc, pin) == param)
-                       arg = 1;
+                       arg = 60000;
                else
                        return -EINVAL;
                break;