media: Documentation: tx-rx: Move transmitter control out of CSI-2 part

The subsection on stopping the transmitter belongs to the generic part and
is not specific to CSI-2. Move it out of the CSI-2 section.

Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Reviewed-by: Tomi Valkeinen <tomi.valkeinen@ideasonboard.com>
Signed-off-by: Hans Verkuil <hverkuil@xs4all.nl>

diff --git a/Documentation/driver-api/media/tx-rx.rst b/Documentation/driver-api/media/tx-rx.rst
index 6f9eba189a9f4241f8899a4a79f32f3c16bc68c9..03768e5aa88f1d6003b061d6bd78c65f93e6c0f8 100644 (file)
--- a/Documentation/driver-api/media/tx-rx.rst
+++ b/Documentation/driver-api/media/tx-rx.rst
@@ -62,6 +62,15 @@ to control the transmitter driver's streaming state. These callbacks may not be
 called directly, but by using ``v4l2_subdev_enable_streams()`` and
 ``v4l2_subdev_disable_streams()``.
 
+Stopping the transmitter
+^^^^^^^^^^^^^^^^^^^^^^^^
+
+A transmitter stops sending the stream of images as a result of
+calling the ``.disable_streams()`` callback. Some transmitters may stop the
+stream at a frame boundary whereas others stop immediately,
+effectively leaving the current frame unfinished. The receiver driver
+should not make assumptions either way, but function properly in both
+cases.
 
 CSI-2 transmitter drivers
 -------------------------
@@ -130,13 +139,3 @@ device, so this should be only done when it is needed.
 
 Receiver drivers that do not need explicit LP-11 or LP-111 state setup are
 waived from calling the two callbacks.
-
-Stopping the transmitter
-^^^^^^^^^^^^^^^^^^^^^^^^
-
-A transmitter stops sending the stream of images as a result of
-calling the ``.disable_streams()`` callback. Some transmitters may stop the
-stream at a frame boundary whereas others stop immediately,
-effectively leaving the current frame unfinished. The receiver driver
-should not make assumptions either way, but function properly in both
-cases.