Add support to configure per-MLO link maximum supported channel width

Update documentation of the QCA_WLAN_VENDOR_ATTR_CONFIG_CHANNEL_WIDTH
and QCA_WLAN_VENDOR_ATTR_CONFIG_CHAN_WIDTH_UPDATE_TYPE attributes to
indicate support for per-MLO link configuration.

Signed-off-by: Veerendranath Jakkam <quic_vjakkam@quicinc.com>

diff --git a/src/common/qca-vendor.h b/src/common/qca-vendor.h
index 47f680fafa781b181972795331ba96f0283b1e6d..b776082f1b954a14299d0c5c2e3b6f39fbe242e5 100644 (file)
--- a/src/common/qca-vendor.h
+++ b/src/common/qca-vendor.h
@@ -2754,6 +2754,9 @@ enum qca_wlan_vendor_attr_config {
         * state, it should not exceed the negotiated channel width. If it is
         * configured when STA is in disconnected state, the configured value
         * will take effect for the next immediate connection.
+        * This configuration can be sent inside
+        * %QCA_WLAN_VENDOR_ATTR_CONFIG_MLO_LINKS to specify the maximum
+        * supported channel width per-MLO link.
         *
         * This uses values defined in enum nl80211_chan_width.
         */
@@ -3125,6 +3128,9 @@ enum qca_wlan_vendor_attr_config {
         * %QCA_WLAN_VENDOR_ATTR_CONFIG_CHANNEL_WIDTH when STA is in connected
         * state. This configuration is applicable only for the current
         * connection. This configuration not allowed in disconnected state.
+        * This configuration can be sent inside
+        * %QCA_WLAN_VENDOR_ATTR_CONFIG_MLO_LINKS to specify the maximum
+        * supported channel width update type per-MLO link.
         *
         * valid values:
         * 0 - The maximum allowed bandwidth change is applicable for both Tx