phy: marvell: phy-mvebu-cp110-comphy: improve eth_port1 on comphy4

According to the CN9100_MPP_information document, CP_SRD4 (comphy 4)
supports 2500 BASE-X and 5000 BASE-R for ETH_PORT1. I was able to test
that 2500 BASE-X is indeed supported. Unfortunately, our HW does not
support 5000 BASE-R, but I assume from the document that it does, so I
set the muxing there too to 0x1.

Signed-off-by: Stefan Eichenberger <eichest@gmail.com>
Link: https://lore.kernel.org/r/20240711131612.98952-1-eichest@gmail.com
Signed-off-by: Vinod Koul <vkoul@kernel.org>

diff --git a/drivers/phy/marvell/phy-mvebu-cp110-comphy.c b/drivers/phy/marvell/phy-mvebu-cp110-comphy.c
index da5e8f4057490ca581109d13c7c8e736cc4b136e..fefc02d921e699c9721ee9f6dc6934f14731c5b6 100644 (file)
--- a/drivers/phy/marvell/phy-mvebu-cp110-comphy.c
+++ b/drivers/phy/marvell/phy-mvebu-cp110-comphy.c
@@ -244,8 +244,8 @@ static const struct mvebu_comphy_conf mvebu_comphy_cp110_modes[] = {
        GEN_CONF(4, 1, PHY_MODE_USB_HOST_SS, COMPHY_FW_MODE_USB3H),
        GEN_CONF(4, 1, PHY_MODE_PCIE, COMPHY_FW_MODE_PCIE),
        ETH_CONF(4, 1, PHY_INTERFACE_MODE_SGMII, 0x1, COMPHY_FW_MODE_SGMII),
-       ETH_CONF(4, 1, PHY_INTERFACE_MODE_2500BASEX, -1, COMPHY_FW_MODE_2500BASEX),
-       ETH_CONF(4, 1, PHY_INTERFACE_MODE_5GBASER, -1, COMPHY_FW_MODE_XFI),
+       ETH_CONF(4, 1, PHY_INTERFACE_MODE_2500BASEX, 0x1, COMPHY_FW_MODE_2500BASEX),
+       ETH_CONF(4, 1, PHY_INTERFACE_MODE_5GBASER, 0x1, COMPHY_FW_MODE_XFI),
        ETH_CONF(4, 1, PHY_INTERFACE_MODE_10GBASER, -1, COMPHY_FW_MODE_XFI),
        /* lane 5 */
        ETH_CONF(5, 1, PHY_INTERFACE_MODE_RXAUI, 0x2, COMPHY_FW_MODE_RXAUI),