clk: qcom: fix RCG M/N counter configuration

commit 0b21503dbbfa669dbd847b33578d4041513cddb2 upstream.

Currently, a RCG's M/N counter (used for fraction division) is
set to either 'bypass' (counter disabled) or 'dual edge' (counter
enabled) based on whether the corresponding rcg struct has a mnd
field specified and a non-zero N.

In the case where M and N are the same value, the M/N counter is
still enabled by code even though no division takes place.
Leaving the RCG in such a state can result in improper behavior.
This was observed with the DSI pixel clock RCG when M and N were
both set to 1.

Add an additional check (M != N) to enable the M/N counter only
when it's needed for fraction division.

Signed-off-by: Archit Taneja <architt@codeaurora.org>
Fixes: bcd61c0f535a (clk: qcom: Add support for root clock
generators (RCGs))
Signed-off-by: Stephen Boyd <sboyd@codeaurora.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/drivers/clk/qcom/clk-rcg2.c b/drivers/clk/qcom/clk-rcg2.c
index 08b8b3729f539ee769f15d1f474e8c3718d1e640..4fe9c01a14b4887a1eab39e087e702c8b8b456d9 100644 (file)
--- a/drivers/clk/qcom/clk-rcg2.c
+++ b/drivers/clk/qcom/clk-rcg2.c
@@ -242,7 +242,7 @@ static int clk_rcg2_configure(struct clk_rcg2 *rcg, const struct freq_tbl *f)
        mask |= CFG_SRC_SEL_MASK | CFG_MODE_MASK;
        cfg = f->pre_div << CFG_SRC_DIV_SHIFT;
        cfg |= rcg->parent_map[f->src] << CFG_SRC_SEL_SHIFT;
-       if (rcg->mnd_width && f->n)
+       if (rcg->mnd_width && f->n && (f->m != f->n))
                cfg |= CFG_MODE_DUAL_EDGE;
        ret = regmap_update_bits(rcg->clkr.regmap,
                        rcg->cmd_rcgr + CFG_REG, mask, cfg);