media: ov5640: Enable MIPI interface in ov5640_set_power_mipi()

[ Upstream commit 98cb72d3b9c5e03b10fa993752ecfcbd9c572d8c ]

Set OV5640_REG_IO_MIPI_CTRL00 bit 2 to 1 instead of 0, since 1 means
MIPI CSI2 interface, while 0 means CPI parallel interface.

In the ov5640_set_power_mipi() the interface should obviously be set
to MIPI CSI2 since this functions is used to power up the sensor when
operated in MIPI CSI2 mode. The sensor should not be in CPI mode in
that case.

This fixes a corner case where capturing the first frame on i.MX8MN
with CSI/ISI resulted in corrupted frame.

Fixes: aa4bb8b8838f ("media: ov5640: Re-work MIPI startup sequence")
Reviewed-by: Jacopo Mondi <jacopo.mondi@ideasonboard.com>
Tested-by: Jacopo Mondi <jacopo.mondi@ideasonboard.com> # [Test on imx6q]
Signed-off-by: Marek Vasut <marex@denx.de>
Tested-by: Jai Luthra <j-luthra@ti.com> # [Test on bplay, sk-am62]
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>

diff --git a/drivers/media/i2c/ov5640.c b/drivers/media/i2c/ov5640.c
index 1bc4d72a906e5d020320a528ea4e82c41e1853a8..74cfe2d373577d2370551e9ce8cc886ed180bdf8 100644 (file)
--- a/drivers/media/i2c/ov5640.c
+++ b/drivers/media/i2c/ov5640.c
@@ -2542,9 +2542,9 @@ static int ov5640_set_power_mipi(struct ov5640_dev *sensor, bool on)
         *                "ov5640_set_stream_mipi()")
         * [4] = 0      : Power up MIPI HS Tx
         * [3] = 0      : Power up MIPI LS Rx
-        * [2] = 0      : MIPI interface disabled
+        * [2] = 1      : MIPI interface enabled
         */
-       ret = ov5640_write_reg(sensor, OV5640_REG_IO_MIPI_CTRL00, 0x40);
+       ret = ov5640_write_reg(sensor, OV5640_REG_IO_MIPI_CTRL00, 0x44);
        if (ret)
                return ret;