From: Gokul Praveen Date: Wed, 21 Jan 2026 06:11:34 +0000 (+0530) Subject: pwm: tiehrpwm: Enable pwmchip's parent device before setting configuration X-Git-Url: http://git.ipfire.org/cgi-bin/gitweb.cgi?a=commitdiff_plain;h=75e7ed52ac7c1da90f304dcda2906636404df921;p=thirdparty%2Fkernel%2Flinux.git pwm: tiehrpwm: Enable pwmchip's parent device before setting configuration The period and duty cycle configurations on J7200 and J784S4 SoCs does not get reflected after setting them using sysfs nodes. This is because at the end of ehrpwm_pwm_config function, the put_sync function is called which resets the hardware. Hold the PWM controller out of low-power mode during .apply() to make sure it accepts the writes to its registers. This renders the calls to pm_runtime_get_sync() and pm_runtime_put_sync() in ehrpwm_pwm_config() into no-ops, so these can be dropped. Fixes: 5f027d9b83db ("pwm: tiehrpwm: Implement .apply() callback") Signed-off-by: Gokul Praveen Suggested-by: Uwe Kleine-König Link: https://patch.msgid.link/20260121061134.15466-1-g-praveen@ti.com Signed-off-by: Uwe Kleine-König --- diff --git a/drivers/pwm/pwm-tiehrpwm.c b/drivers/pwm/pwm-tiehrpwm.c index 7a86cb090f76f..2533c95b0ba9d 100644 --- a/drivers/pwm/pwm-tiehrpwm.c +++ b/drivers/pwm/pwm-tiehrpwm.c @@ -237,8 +237,6 @@ static int ehrpwm_pwm_config(struct pwm_chip *chip, struct pwm_device *pwm, if (period_cycles < 1) period_cycles = 1; - pm_runtime_get_sync(pwmchip_parent(chip)); - /* Update clock prescaler values */ ehrpwm_modify(pc->mmio_base, TBCTL, TBCTL_CLKDIV_MASK, tb_divval); @@ -290,8 +288,6 @@ static int ehrpwm_pwm_config(struct pwm_chip *chip, struct pwm_device *pwm, if (!(duty_cycles > period_cycles)) ehrpwm_write(pc->mmio_base, cmp_reg, duty_cycles); - pm_runtime_put_sync(pwmchip_parent(chip)); - return 0; } @@ -378,6 +374,8 @@ static int ehrpwm_pwm_apply(struct pwm_chip *chip, struct pwm_device *pwm, int err; bool enabled = pwm->state.enabled; + guard(pm_runtime_active)(pwmchip_parent(chip)); + if (state->polarity != pwm->state.polarity) { if (enabled) { ehrpwm_pwm_disable(chip, pwm);