From: Gabor Juhos Date: Fri, 20 Feb 2026 10:03:49 +0000 (+0100) Subject: arm64: dts: marvell: armada-37xx: align 'phy-names' of EHCI node with DT schema X-Git-Tag: v7.1-rc1~41^2~5^2~4 X-Git-Url: http://git.ipfire.org/cgi-bin/gitweb.cgi?a=commitdiff_plain;h=b6453dd68e7329b2954ed9a3552095919889a4a9;p=thirdparty%2Fkernel%2Flinux.git arm64: dts: marvell: armada-37xx: align 'phy-names' of EHCI node with DT schema According to the 'generic-ehci.yaml' schema, the name of the first phy in an EHCI node must be "usb", however the 'usb@5e000' node in the 'armada-37xx.dtsi' uses "usb2-utmi-host-phy" instead. This causes dtbs_check warnings like the following ones: arch/arm64/boot/dts/marvell/armada-3720-atlas-v5.dtb: usb@5e000 (marvell,armada-3700-ehci): phy-names:0: 'usb' was expected from schema $id: http://devicetree.org/schemas/usb/generic-ehci.yaml arch/arm64/boot/dts/marvell/armada-3720-db.dtb: usb@5e000 (marvell,armada-3700-ehci): phy-names:0: 'usb' was expected from schema $id: http://devicetree.org/schemas/usb/generic-ehci.yaml arch/arm64/boot/dts/marvell/armada-3720-eDPU.dtb: usb@5e000 (marvell,armada-3700-ehci): phy-names:0: 'usb' was expected from schema $id: http://devicetree.org/schemas/usb/generic-ehci.yaml ... Use "usb" as a name for the phy to avoid the warnings. No functional change, the USB interface works after the change: [ 1.472393] orion-ehci d005e000.usb: EHCI Host Controller [ 1.477847] orion-ehci d005e000.usb: new USB bus registered, assigned bus number 1 [ 1.487127] orion-ehci d005e000.usb: irq 40, io mem 0xd005e000 [ 1.505759] orion-ehci d005e000.usb: USB 2.0 started, EHCI 1.00 [ 1.512493] hub 1-0:1.0: USB hub found [ 1.516434] hub 1-0:1.0: 1 port detected ... [ 4.175746] usb 1-1: new high-speed USB device number 2 using orion-ehci [ 4.347643] usb-storage 1-1:1.0: USB Mass Storage device detected [ 4.359972] scsi host0: usb-storage 1-1:1.0 [ 5.367100] scsi 0:0:0:0: Direct-Access ADATA USB Flash Drive 1.00 PQ: 0 ANSI: 6 [ 5.387091] sd 0:0:0:0: [sda] 30869504 512-byte logical blocks: (15.8 GB/14.7 GiB) [ 5.398420] sd 0:0:0:0: [sda] Write Protect is off [ 5.408108] sd 0:0:0:0: [sda] Write cache: disabled, read cache: disabled, doesn't support DPO or FUA [ 5.477359] sda: sda1 [ 5.480037] sd 0:0:0:0: [sda] Attached SCSI removable disk Signed-off-by: Gabor Juhos Signed-off-by: Gregory CLEMENT --- diff --git a/arch/arm64/boot/dts/marvell/armada-37xx.dtsi b/arch/arm64/boot/dts/marvell/armada-37xx.dtsi index 87f9367aec12..a8d10e4de816 100644 --- a/arch/arm64/boot/dts/marvell/armada-37xx.dtsi +++ b/arch/arm64/boot/dts/marvell/armada-37xx.dtsi @@ -396,7 +396,7 @@ marvell,usb-misc-reg = <&usb2_syscon>; interrupts = ; phys = <&usb2_utmi_host_phy>; - phy-names = "usb2-utmi-host-phy"; + phy-names = "usb"; status = "disabled"; };