From: Grygorii Strashko Date: Thu, 21 Dec 2017 00:45:10 +0000 (-0600) Subject: net: phy: micrel: ksz9031: reconfigure autoneg after phy autoneg workaround X-Git-Tag: v4.15-rc6~21^2~17 X-Git-Url: http://git.ipfire.org/cgi-bin/gitweb.cgi?a=commitdiff_plain;h=c1a8d0a3accf64a014d605e6806ce05d1c17adf1;p=thirdparty%2Fkernel%2Flinux.git net: phy: micrel: ksz9031: reconfigure autoneg after phy autoneg workaround Under some circumstances driver will perform PHY reset in ksz9031_read_status() to fix autoneg failure case (idle error count = 0xFF). When this happens ksz9031 will not detect link status change any more when connecting to Netgear 1G switch (link can be recovered sometimes by restarting netdevice "ifconfig down up"). Reproduced with TI am572x board equipped with ksz9031 PHY while connecting to Netgear 1G switch. Fix the issue by reconfiguring autonegotiation after PHY reset in ksz9031_read_status(). Fixes: d2fd719bcb0e ("net/phy: micrel: Add workaround for bad autoneg") Signed-off-by: Grygorii Strashko Signed-off-by: David S. Miller --- diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c index ab46141134034..422ff6333c52d 100644 --- a/drivers/net/phy/micrel.c +++ b/drivers/net/phy/micrel.c @@ -624,6 +624,7 @@ static int ksz9031_read_status(struct phy_device *phydev) phydev->link = 0; if (phydev->drv->config_intr && phy_interrupt_is_valid(phydev)) phydev->drv->config_intr(phydev); + return genphy_config_aneg(phydev); } return 0;