From 088eb0f161c58969bc7544e5d6c1451ed18d2ddb Mon Sep 17 00:00:00 2001 From: Takashi Sakamoto Date: Mon, 9 Jun 2025 08:38:06 +0900 Subject: [PATCH] firewire: ohci: correct code comments about bus_reset tasklet The tasklet for bus reset event has been replaced with work item, while some code comments still address to the tasklet. This commit corrects them. Fixes: 2d7a36e23300 ("firewire: ohci: Move code from the bus reset tasklet into a workqueue") Link: https://lore.kernel.org/r/20250608233808.202355-1-o-takashi@sakamocchi.jp Signed-off-by: Takashi Sakamoto --- drivers/firewire/ohci.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/firewire/ohci.c b/drivers/firewire/ohci.c index edaedd156a6da..27e3e998e6fc7 100644 --- a/drivers/firewire/ohci.c +++ b/drivers/firewire/ohci.c @@ -2528,7 +2528,7 @@ static int ohci_enable(struct fw_card *card, * They shouldn't do that in this initial case where the link * isn't enabled. This means we have to use the same * workaround here, setting the bus header to 0 and then write - * the right values in the bus reset tasklet. + * the right values in the bus reset work item. */ if (config_rom) { @@ -2617,7 +2617,7 @@ static int ohci_set_config_rom(struct fw_card *card, * during the atomic update, even on little endian * architectures. The workaround we use is to put a 0 in the * header quadlet; 0 is endian agnostic and means that the - * config rom isn't ready yet. In the bus reset tasklet we + * config rom isn't ready yet. In the bus reset work item we * then set up the real values for the two registers. * * We use ohci->lock to avoid racing with the code that sets @@ -2659,7 +2659,7 @@ static int ohci_set_config_rom(struct fw_card *card, /* * Now initiate a bus reset to have the changes take * effect. We clean up the old config rom memory and DMA - * mappings in the bus reset tasklet, since the OHCI + * mappings in the bus reset work item, since the OHCI * controller could need to access it before the bus reset * takes effect. */ -- 2.47.2