net: zynq: Use predefined macros instead of hardcoded value

MII is used by this driver.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>

diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index 9471b31e8967c3bf55f32b2c116c49b97a96cb2e..4ce12f9a738552447350b62bd3856fdbec6b5c21 100644 (file)
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -356,7 +356,8 @@ static int zynq_gem_init(struct eth_device *dev, bd_t * bis)
 
 #ifdef CONFIG_PHYLIB
        /* interface - look at tsec */
-       phydev = phy_connect(priv->bus, priv->phyaddr, dev, 0);
+       phydev = phy_connect(priv->bus, priv->phyaddr, dev,
+                            PHY_INTERFACE_MODE_MII);
 
        phydev->supported = supported | ADVERTISED_Pause |
                            ADVERTISED_Asym_Pause;