configs: apalis-imx8: Enable EFI

Enable standard EFI support, as required for booting standard aarch64
Linux distribution, following the ARM recommendations for SystemReady
compliance [1].

The RTC used on this board is not currently supported by U-Boot,
therefore it is not enabled at the moment.

Link: https://developer.arm.com/documentation/DUI1101/4-5/Configure-U-Boot-for-SystemReady
Signed-off-by: Francesco Dolcini <francesco.dolcini@toradex.com>

diff --git a/configs/apalis-imx8_defconfig b/configs/apalis-imx8_defconfig
index 6ab4dd3dc57525505cec97905d8f3b93643ac970..f50ef140f6be4034b4388c25070bdaa6ca5595b7 100644 (file)
--- a/configs/apalis-imx8_defconfig
+++ b/configs/apalis-imx8_defconfig
@@ -18,7 +18,6 @@ CONFIG_IMX_BOOTAUX=y
 CONFIG_SYS_MEMTEST_START=0x88000000
 CONFIG_SYS_MEMTEST_END=0x89000000
 CONFIG_REMAKE_ELF=y
-# CONFIG_EFI_LOADER is not set
 CONFIG_FIT=y
 CONFIG_FIT_VERBOSE=y
 CONFIG_DISTRO_DEFAULTS=y
@@ -35,11 +34,13 @@ CONFIG_BOARD_EARLY_INIT_F=y
 CONFIG_SYS_PROMPT="Apalis iMX8 # "
 CONFIG_CMD_CPU=y
 CONFIG_CMD_ASKENV=y
+CONFIG_CMD_NVEDIT_EFI=y
 CONFIG_CMD_MEMTEST=y
 CONFIG_CMD_CLK=y
 CONFIG_CMD_DM=y
 CONFIG_CMD_FUSE=y
 CONFIG_CMD_GPIO=y
+CONFIG_CMD_GPT=y
 CONFIG_CMD_I2C=y
 CONFIG_CMD_MMC=y
 CONFIG_CMD_CACHE=y