net: xilinx_axi: Clear Isolate bit if found set suring phy

In SGMII cases the isolate bit might set after DMA and
ethernet resets and hence check and clear during
setup_phy if it was set.

Signed-off-by: Siva Durga Prasad Paladugu <sivadur@xilinx.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>

diff --git a/drivers/net/xilinx_axi_emac.c b/drivers/net/xilinx_axi_emac.c
index 74f9a693ef8cdcd85e8999c049218609cf09c763..b50237e1f03cdd44eeeb3d7666affcebc2cf9f03 100644 (file)
--- a/drivers/net/xilinx_axi_emac.c
+++ b/drivers/net/xilinx_axi_emac.c
@@ -269,6 +269,23 @@ static int setup_phy(struct udevice *dev)
        struct axi_regs *regs = priv->iobase;
        struct phy_device *phydev = priv->phydev;
 
+       if (priv->interface == PHY_INTERFACE_MODE_SGMII) {
+               /*
+                * In SGMII cases the isolate bit might set
+                * after DMA and ethernet resets and hence
+                * check and clear if set.
+                */
+               ret = phyread(priv, priv->phyaddr, MII_BMCR, &temp);
+               if (ret)
+                       return 0;
+               if (temp & BMCR_ISOLATE) {
+                       temp &= ~BMCR_ISOLATE;
+                       ret = phywrite(priv, priv->phyaddr, MII_BMCR, temp);
+                       if (ret)
+                               return 0;
+               }
+       }
+
        if (phy_startup(phydev)) {
                printf("axiemac: could not initialize PHY %s\n",
                       phydev->dev->name);