amd-xgbe: propagate the correct speed and duplex status

xgbe_get_link_ksettings() does not propagate correct speed and duplex
information to ethtool during cable unplug. Due to which ethtool reports
incorrect values for speed and duplex.

Address this by propagating correct information.

Fixes: 7c12aa08779c ("amd-xgbe: Move the PHY support into amd-xgbe")
Acked-by: Shyam Sundar S K <Shyam-sundar.S-k@amd.com>
Signed-off-by: Raju Rangoju <Raju.Rangoju@amd.com>
Reviewed-by: Wojciech Drewek <wojciech.drewek@intel.com>
Signed-off-by: Paolo Abeni <pabeni@redhat.com>

diff --git a/drivers/net/ethernet/amd/xgbe/xgbe-ethtool.c b/drivers/net/ethernet/amd/xgbe/xgbe-ethtool.c
index 6e83ff59172a36b66d1442dc32b338edfe3d5773..32fab5e7724626f856da6c17ae9df2c92241b0c1 100644 (file)
--- a/drivers/net/ethernet/amd/xgbe/xgbe-ethtool.c
+++ b/drivers/net/ethernet/amd/xgbe/xgbe-ethtool.c
@@ -314,10 +314,15 @@ static int xgbe_get_link_ksettings(struct net_device *netdev,
 
        cmd->base.phy_address = pdata->phy.address;
 
-       cmd->base.autoneg = pdata->phy.autoneg;
-       cmd->base.speed = pdata->phy.speed;
-       cmd->base.duplex = pdata->phy.duplex;
+       if (netif_carrier_ok(netdev)) {
+               cmd->base.speed = pdata->phy.speed;
+               cmd->base.duplex = pdata->phy.duplex;
+       } else {
+               cmd->base.speed = SPEED_UNKNOWN;
+               cmd->base.duplex = DUPLEX_UNKNOWN;
+       }
 
+       cmd->base.autoneg = pdata->phy.autoneg;
        cmd->base.port = PORT_NONE;
 
        XGBE_LM_COPY(cmd, supported, lks, supported);