thunderbolt: Increase timeout for Configuration Ready bit

After setting the Configuration Valid bit (ROUTER_CS_5.CV), the USB4
Connection Manager guide specifies a 500 ms timeout for the router to
set the Configuration Ready bit (ROUTER_CS_6.CR). The current timeout
is shorter than specified. While there, fix the kernel-doc typo.

Increase the timeout to match the CM guide recommendation.

Signed-off-by: Gil Fine <gil.fine@linux.intel.com>
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>

diff --git a/drivers/thunderbolt/usb4.c b/drivers/thunderbolt/usb4.c
index 54f4f5fa3c5af076a5ece51845f8b9f92165ec7f..5fd4fe070f25844c28a4ba7fda149edfc2014c3a 100644 (file)
--- a/drivers/thunderbolt/usb4.c
+++ b/drivers/thunderbolt/usb4.c
@@ -309,7 +309,7 @@ int usb4_switch_setup(struct tb_switch *sw)
  * Sets configuration valid bit for the router. Must be called before
  * any tunnels can be set through the router and after
  * usb4_switch_setup() has been called. Can be called to host and device
- * routers (does nothing for the latter).
+ * routers (does nothing for the former).
  *
  * Return: %0 on success, negative errno otherwise.
  */
@@ -332,7 +332,7 @@ int usb4_switch_configuration_valid(struct tb_switch *sw)
                return ret;
 
        return tb_switch_wait_for_bit(sw, ROUTER_CS_6, ROUTER_CS_6_CR,
-                                     ROUTER_CS_6_CR, 50);
+                                     ROUTER_CS_6_CR, 500);
 }
 
 /**