From: Rajan Vaja <rajan.vaja@xilinx.com>
Date: Thu, 1 Feb 2018 04:59:16 +0000 (-0800)
Subject: arm64: zynqmp: remove pin-control properties
X-Git-Url: http://git.ipfire.org/gitweb.cgi?a=commitdiff_plain;h=971472139b340559d65f161cd0da16c0623d2c15;p=thirdparty%2Fu-boot.git

arm64: zynqmp: remove pin-control properties

Remove pin control from firmware device tree binding as
pin control settings for firmware are done in firmware only.
Remove the same from bindings documentation.

Signed-off-by: Rajan Vaja <rajanv@xilinx.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
---

diff --git a/arch/arm/dts/zynqmp-zcu100-revC.dts b/arch/arm/dts/zynqmp-zcu100-revC.dts
index 8aa6a36a823..5c146699aa2 100644
--- a/arch/arm/dts/zynqmp-zcu100-revC.dts
+++ b/arch/arm/dts/zynqmp-zcu100-revC.dts
@@ -143,11 +143,6 @@
 	status = "okay";
 };
 
-&pmufw {
-	pinctrl-names = "default";
-	pinctrl-0 = <&pinctrl_pmu_default>;
-};
-
 &gpio {
 	status = "okay";
 	gpio-line-names = "UART1_TX", "UART1_RX", "UART0_RX", "UART0_TX", "I2C1_SCL",
@@ -415,20 +410,6 @@
 		};
 	};
 
-	pinctrl_pmu_default: pmu-default {
-		mux {
-			groups = "pmu0_8_grp";
-			function = "pmu0";
-		};
-
-		conf {
-			groups = "pmu0_8_grp";
-			bias-pull-up;
-			slew-rate = <SLEW_RATE_SLOW>;
-			io-standard = <IO_STANDARD_LVCMOS18>;
-		};
-	};
-
 	pinctrl_sdhci0_default: sdhci0-default {
 		mux {
 			groups = "sdio0_4bit_0_0_grp";