From: Darell Tan Date: Sat, 6 Jun 2026 11:35:53 +0000 (+0000) Subject: realtek: rtl930x: add support for Sirivision SR-ST3408F X-Git-Url: http://git.ipfire.org/gitweb.cgi?a=commitdiff_plain;h=refs%2Fpull%2F23686%2Fhead;p=thirdparty%2Fopenwrt.git realtek: rtl930x: add support for Sirivision SR-ST3408F This commit adds support for the Sirivision SR-ST3408F, an 8-port 10G switch with 4x RJ45 ports and 4x SFP ports. SoC: Realtek RTL9303 RAM: 512 MiB DDR3 Flash: SPI-NOR 16 MiB (Winbond) Ethernet: 4x RJ45 via RTL8261BE PHY (10G/5G/2.5G/1G/100M/10M) 4x SFP+ LEDs: 1x power, 1x system green 2x RJ45 LEDs/port (link/act, 10G) 1x SFP+ LED/port (link/act) Button: Reset Console: Cisco-style RJ45, 115200 8n1 Fan: 4040 12V fan (hardwired) Power: 12V 3A internal PSU OpenWrt installation --------------------- 1. Attach to serial console using a Cisco cable, 115200 8n1 2. Power on the switch and rapidly press Esc to interrupt U-Boot 3. Initialize the RJ45 ports by running `rtk network on` 4. Serve the initramfs-kernel.bin image on TFTP, IP 192.168.1.111 5. Use any RJ45 port to connect to your TFTP server 6. Run `tftpboot 0x81000000 initramfs-kernel.bin; bootm` 7. Use `mtd dump` or `dd` to backup the original firmware at `mtd5` first 8. Run sysupgrade to flash sysupgrade.bin into the switch and reboot Restoring original firmware ----------------------------- Vendor does not provide firmware images, so you should have made a backup. Use `mtd write` to restore your backed up copy into the `mtd5` partition. MAC Address ------------ All interfaces are assigned the same MAC address, from the U-Boot env `ethaddr`. This MAC address is also printed on the device label. Signed-off-by: Darell Tan Link: https://github.com/openwrt/openwrt/pull/23686 Signed-off-by: Jonas Jelonek --- diff --git a/target/linux/realtek/base-files/etc/board.d/02_network b/target/linux/realtek/base-files/etc/board.d/02_network index 11c76730079..a85fbfc173e 100644 --- a/target/linux/realtek/base-files/etc/board.d/02_network +++ b/target/linux/realtek/base-files/etc/board.d/02_network @@ -93,6 +93,7 @@ realtek_setup_macs() plasmacloud,psx8|\ plasmacloud,psx10|\ plasmacloud,psx28|\ + sirivision,sr-st3408f|\ zyxel,gs1920-24hp-v2) lan_mac="$(get_mac_label)" ;; diff --git a/target/linux/realtek/dts/rtl9303_sirivision_sr-st3408f.dts b/target/linux/realtek/dts/rtl9303_sirivision_sr-st3408f.dts new file mode 100644 index 00000000000..067dbd1057f --- /dev/null +++ b/target/linux/realtek/dts/rtl9303_sirivision_sr-st3408f.dts @@ -0,0 +1,261 @@ +// SPDX-License-Identifier: GPL-2.0-or-later +/dts-v1/; + +#include "rtl930x.dtsi" + +#include +#include +#include +#include + +/ { + compatible = "sirivision,sr-st3408f", "realtek,rtl9303-soc"; + model = "Sirivision SR-ST3408F"; + + memory@0 { + device_type = "memory"; + reg = <0x00000000 0x10000000>, /* first 256 MiB */ + <0x20000000 0x10000000>; /* remaining 256 MiB */ + }; + + chosen { + stdout-path = "serial0:115200n8"; + }; + + aliases { + led-boot = &led_sys; + led-failsafe = &led_sys; + led-running = &led_sys; + led-upgrade = &led_sys; + + label-mac-device = ðernet0; + }; + + keys { + compatible = "gpio-keys"; + + button-reset { + label = "reset"; + gpios = <&gpio0 12 GPIO_ACTIVE_LOW>; + linux,code = ; + }; + }; + + leds { + compatible = "gpio-leds"; + + led_sys: led-0 { + gpios = <&gpio0 0 GPIO_ACTIVE_HIGH>; + color = ; + function = LED_FUNCTION_STATUS; + }; + }; + + led_set { + compatible = "realtek,rtl9300-leds"; + active-low; + + led_set0 = < + (RTL93XX_LED_SET_10G | RTL93XX_LED_SET_LINK) + (RTL93XX_LED_SET_10G | RTL93XX_LED_SET_5G | RTL93XX_LED_SET_2P5G | + RTL93XX_LED_SET_1G | RTL93XX_LED_SET_100M | RTL93XX_LED_SET_10M | + RTL93XX_LED_SET_LINK | RTL93XX_LED_SET_ACT) + >; + + led_set1 = < + (RTL93XX_LED_SET_NONE) /* odd outputs are not connected */ + (RTL93XX_LED_SET_10G | RTL93XX_LED_SET_5G | RTL93XX_LED_SET_2P5G | + RTL93XX_LED_SET_1G | RTL93XX_LED_SET_100M | RTL93XX_LED_SET_10M | + RTL93XX_LED_SET_LINK | RTL93XX_LED_SET_ACT) + >; + }; + + sfp0: sfp-p5 { + compatible = "sff,sfp"; + i2c-bus = <&i2c4>; + tx-disable-gpio = <&gpio1 12 GPIO_ACTIVE_HIGH>; + mod-def0-gpio = <&gpio1 13 GPIO_ACTIVE_LOW>; + los-gpio = <&gpio1 14 GPIO_ACTIVE_HIGH>; + maximum-power-milliwatt = <2000>; + #thermal-sensor-cells = <0>; + }; + + sfp1: sfp-p6 { + compatible = "sff,sfp"; + i2c-bus = <&i2c5>; + tx-disable-gpio = <&gpio1 21 GPIO_ACTIVE_HIGH>; + mod-def0-gpio = <&gpio1 22 GPIO_ACTIVE_LOW>; + los-gpio = <&gpio1 23 GPIO_ACTIVE_HIGH>; + maximum-power-milliwatt = <2000>; + #thermal-sensor-cells = <0>; + }; + + sfp2: sfp-p7 { + compatible = "sff,sfp"; + i2c-bus = <&i2c6>; + tx-disable-gpio = <&gpio1 24 GPIO_ACTIVE_HIGH>; + mod-def0-gpio = <&gpio1 25 GPIO_ACTIVE_LOW>; + los-gpio = <&gpio1 26 GPIO_ACTIVE_HIGH>; + maximum-power-milliwatt = <2000>; + #thermal-sensor-cells = <0>; + }; + + sfp3: sfp-p8 { + compatible = "sff,sfp"; + i2c-bus = <&i2c7>; + tx-disable-gpio = <&gpio1 27 GPIO_ACTIVE_HIGH>; + mod-def0-gpio = <&gpio1 28 GPIO_ACTIVE_LOW>; + los-gpio = <&gpio1 29 GPIO_ACTIVE_HIGH>; + maximum-power-milliwatt = <2000>; + #thermal-sensor-cells = <0>; + }; +}; + +&i2c_mst1 { + status = "okay"; + + i2c4: i2c@4 { reg = <4>; }; + i2c5: i2c@5 { reg = <5>; }; + i2c6: i2c@6 { reg = <6>; }; + i2c7: i2c@7 { reg = <7>; }; +}; + +&mdio_aux { + status = "okay"; + + gpio1: gpio@0 { + compatible = "realtek,rtl8231"; + reg = <0>; + + gpio-controller; + #gpio-cells = <2>; + gpio-ranges = <&gpio1 0 0 37>; + + led-controller { + compatible = "realtek,rtl8231-leds"; + status = "disabled"; + }; + }; +}; + +&spi0 { + status = "okay"; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <10000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x0 0xe0000>; + read-only; + }; + + partition@e0000 { + label = "u-boot-env"; + reg = <0xe0000 0x10000>; + + nvmem-layout { + compatible = "u-boot,env"; + + macaddr_ubootenv_ethaddr: ethaddr { + #nvmem-cell-cells = <1>; + }; + }; + }; + + partition@f0000 { + label = "u-boot-env2"; + reg = <0xf0000 0x10000>; + read-only; + }; + + partition@100000 { + label = "jffs"; + reg = <0x100000 0x100000>; + }; + + partition@200000 { + label = "jffs2"; + reg = <0x200000 0x100000>; + }; + + partition@300000 { + label = "firmware"; + reg = <0x300000 0xd00000>; + compatible = "openwrt,uimage", "denx,uimage"; + openwrt,ih-magic = <0x93000000>; + }; + }; + }; +}; + +/* serdes for 10G PHYs have TX polarity inverted */ +&serdes2 { tx-polarity = ; }; +&serdes3 { tx-polarity = ; }; +&serdes4 { tx-polarity = ; }; +&serdes5 { tx-polarity = ; }; + +&mdio_bus0 { + PHY_C45(0, 0) + PHY_C45(8, 1) + PHY_C45(16, 2) + PHY_C45(20, 3) +}; + +ðernet0 { + nvmem-cells = <&macaddr_ubootenv_ethaddr 0>; + nvmem-cell-names = "mac-address"; +}; + +&switch0 { + ethernet-ports { + #address-cells = <1>; + #size-cells = <0>; + + /* RJ45 ports, lan1-4 */ + SWITCH_PORT_LED(0, 1, 2, 0, 0, usxgmii) + SWITCH_PORT_LED(8, 2, 3, 0, 0, usxgmii) + SWITCH_PORT_LED(16, 3, 4, 0, 0, usxgmii) + SWITCH_PORT_LED(20, 4, 5, 0, 0, usxgmii) + + /* SFP+ ports, lan5-8 */ + SWITCH_PORT_SFP(24, 5, 6, 1, 0) + SWITCH_PORT_SFP(25, 6, 7, 1, 1) + SWITCH_PORT_SFP(26, 7, 8, 1, 2) + SWITCH_PORT_SFP(27, 8, 9, 1, 3) + + /* CPU port */ + port@28 { + ethernet = <ðernet0>; + reg = <28>; + phy-mode = "internal"; + + fixed-link { + speed = <1000>; + full-duplex; + }; + }; + }; +}; + +&thermal_zones { + sfp-thermal { + polling-delay-passive = <10000>; + polling-delay = <10000>; + thermal-sensors = <&sfp0>, <&sfp1>, <&sfp2>, <&sfp3>; + trips { + sfp-crit { + temperature = <110000>; + hysteresis = <1000>; + type = "critical"; + }; + }; + }; +}; diff --git a/target/linux/realtek/image/rtl930x.mk b/target/linux/realtek/image/rtl930x.mk index 2ae8677e400..9b01f629ac2 100644 --- a/target/linux/realtek/image/rtl930x.mk +++ b/target/linux/realtek/image/rtl930x.mk @@ -12,6 +12,17 @@ define Device/d-link_dgs-1250-28x endef TARGET_DEVICES += d-link_dgs-1250-28x +define Device/sirivision_sr-st3408f + SOC := rtl9303 + UIMAGE_MAGIC := 0x93000000 + DEVICE_VENDOR := Sirivision + DEVICE_MODEL := SR-ST3408F + DEVICE_PACKAGES := kmod-phy-realtek rtl8261n-firmware + IMAGE_SIZE := 13312k + $(Device/kernel-lzma) +endef +TARGET_DEVICES += sirivision_sr-st3408f + define Device/hasivo_f1100w-4sx-4xgt-common SOC := rtl9303 DEVICE_VENDOR := Hasivo