From: Vasilis van Gemert <github@vasilis.nl>
Date: Wed, 30 Jun 2021 16:35:19 +0000 (+0200)
Subject: Chapters about optimising boot time and about read-only
X-Git-Tag: 3.3.9~22^2
X-Git-Url: http://git.ipfire.org/gitweb/gitweb.cgi?a=commitdiff_plain;h=refs%2Fpull%2F1214%2Fhead;p=thirdparty%2Fshairport-sync.git

Chapters about optimising boot time and about read-only

I added a chapter about disabling unnecessary services in order to decrease boot-time. And I added a short tip about read-only mode.
---

diff --git a/CAR INSTALL.md b/CAR INSTALL.md
index 062b6df5..b24c86c7 100644
--- a/CAR INSTALL.md	
+++ b/CAR INSTALL.md	
@@ -193,6 +193,24 @@ denyinterfaces wlan0
 ```
 From this point on, at least on the Raspberry Pi, if you reboot the machine, it will not reconnect to your network – instead, it will act as the WiFi base station you have configured with `hostapd` and `isc-dhcp-server`.
 
+### Optimise startup time
+
+There are quite a few services that are not necessary for this setup. Disabling them can increase startup time. Running these commands disables them:
+
+````
+sudo systemctl disable systemd-timesyncd.service
+sudo systemctl disable keyboard-setup.service
+sudo systemctl disable triggerhappy.service
+sudo systemctl disable dhcpcd.service
+sudo systemctl disable wpa_supplicant.service
+sudo systemctl disable dphys-swapfile.service
+sudo systemctl disable networking.service
+````
+
+### Read-only mode
+
+Run `sudo raspi-config` and then choose `Performance Options` > `Overlay Filesystem` and choose to enable the overlay filesystem, and to set the boot partition to be write-protected. 
+
 ### Ready
 Install the Raspberry Pi in your car. It should be powered from a source that is switched off when you leave the car, otherwise the slight current drain will eventually flatten the car's battery.