]>
Commit | Line | Data |
---|---|---|
569a191a MV |
1 | /* |
2 | * Copyright (C) 2015 Marek Vasut <marex@denx.de> | |
3 | * | |
4 | * SPDX-License-Identifier: GPL-2.0+ | |
5 | */ | |
6 | #ifndef __CONFIG_SAMTEC_VINING_FPGA_H__ | |
7 | #define __CONFIG_SAMTEC_VINING_FPGA_H__ | |
8 | ||
9 | #include <asm/arch/base_addr_ac5.h> | |
10 | ||
11 | /* U-Boot Commands */ | |
12 | #define CONFIG_SYS_NO_FLASH | |
569a191a MV |
13 | #define CONFIG_FAT_WRITE |
14 | #define CONFIG_HW_WATCHDOG | |
15 | ||
16 | #define CONFIG_CMD_EEPROM | |
569a191a MV |
17 | |
18 | /* Memory configurations */ | |
19 | #define PHYS_SDRAM_1_SIZE 0x40000000 /* 1GiB on VINING_FPGA */ | |
20 | ||
21 | /* Booting Linux */ | |
569a191a MV |
22 | #define CONFIG_BOOTFILE "openwrt-socfpga-socfpga_cyclone5_vining_fpga-fit-uImage.itb" |
23 | #define CONFIG_BOOTARGS "console=ttyS0," __stringify(CONFIG_BAUDRATE) | |
24 | #define CONFIG_BOOTCOMMAND "run selboot" | |
25 | #define CONFIG_LOADADDR 0x01000000 | |
26 | #define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR | |
27 | ||
28 | /* I2C EEPROM */ | |
29 | #ifdef CONFIG_CMD_EEPROM | |
30 | #define CONFIG_SYS_I2C_EEPROM_ADDR 0x50 | |
31 | #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 | |
32 | #define CONFIG_SYS_I2C_EEPROM_BUS 0 | |
33 | #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3 | |
34 | #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 70 | |
35 | #endif | |
36 | ||
37 | /* | |
38 | * Status LEDs: | |
39 | * 0 ... Top Green | |
40 | * 1 ... Top Red | |
41 | * 2 ... Bottom Green | |
42 | * 3 ... Bottom Red | |
43 | */ | |
569a191a MV |
44 | |
45 | /* Ethernet on SoC (EMAC) */ | |
46 | #if defined(CONFIG_CMD_NET) | |
47 | #define CONFIG_BOOTP_SEND_HOSTNAME | |
48 | /* PHY */ | |
49 | #define CONFIG_PHY_MICREL | |
50 | #define CONFIG_PHY_MICREL_KSZ9021 | |
51 | #endif | |
52 | ||
53 | /* Extra Environment */ | |
54 | #define CONFIG_HOSTNAME socfpga_vining_fpga | |
55 | ||
56 | /* | |
57 | * Active LOW GPIO buttons: | |
58 | * A: GPIO 77 ... the button between USB B and ethernet | |
59 | * B: GPIO 78 ... the button between USB A ports | |
60 | * | |
61 | * The logic: | |
62 | * if button B is not pressed, boot normal Linux system immediatelly | |
63 | * if button B is pressed, wait $bootdelay and boot recovery system | |
64 | */ | |
65 | #define CONFIG_PREBOOT \ | |
66 | "setenv hostname vining-${unit_serial} ; " \ | |
67 | "setenv PS1 \"${unit_ident} (${unit_serial}) => \" ; " \ | |
68 | "if gpio input 78 ; then " \ | |
69 | "setenv bootdelay 10 ; " \ | |
70 | "setenv boottype rcvr ; " \ | |
71 | "else " \ | |
72 | "setenv bootdelay 5 ; " \ | |
73 | "setenv boottype norm ; " \ | |
74 | "fi" | |
75 | ||
76 | #define CONFIG_EXTRA_ENV_SETTINGS \ | |
77 | "verify=n\0" \ | |
78 | "consdev=ttyS0\0" \ | |
79 | "baudrate=115200\0" \ | |
80 | "bootscript=boot.scr\0" \ | |
81 | "ubimtdnr=5\0" \ | |
82 | "ubimtd=rootfs\0" \ | |
83 | "ubipart=ubi0:rootfs\0" \ | |
84 | "ubisfcs=1\0" /* Default is flash at CS#1 */ \ | |
85 | "netdev=eth0\0" \ | |
86 | "hostname=vining_fpga\0" \ | |
87 | "kernel_addr_r=0x10000000\0" \ | |
88 | "mtdparts_0=ff705000.spi.0:" \ | |
89 | "1m(u-boot)," \ | |
90 | "64k(env1)," \ | |
91 | "64k(env2)," \ | |
92 | "256k(samtec1)," \ | |
93 | "256k(samtec2)," \ | |
94 | "-(rcvrfs)\0" /* Recovery */ \ | |
95 | "mtdparts_1=ff705000.spi.1:" \ | |
96 | "32m(rootfs)," \ | |
97 | "-(userfs)\0" \ | |
98 | "update_filename=u-boot-with-spl-dtb.sfp\0" \ | |
99 | "update_qspi_offset=0x0\0" \ | |
100 | "update_qspi=" /* Update the QSPI firmware */ \ | |
101 | "if sf probe ; then " \ | |
102 | "if tftp ${update_filename} ; then " \ | |
103 | "sf update ${loadaddr} ${update_qspi_offset} ${filesize} ; " \ | |
104 | "fi ; " \ | |
105 | "fi\0" \ | |
106 | "fpga_filename=output_file.rbf\0" \ | |
107 | "load_fpga=" /* Load FPGA bitstream */ \ | |
108 | "if tftp ${fpga_filename} ; then " \ | |
109 | "fpga load 0 $loadaddr $filesize ; " \ | |
110 | "bridge enable ; " \ | |
111 | "fi\0" \ | |
112 | "addcons=" \ | |
113 | "setenv bootargs ${bootargs} " \ | |
114 | "console=${consdev},${baudrate}\0" \ | |
115 | "addip=" \ | |
116 | "setenv bootargs ${bootargs} " \ | |
117 | "ip=${ipaddr}:${serverip}:${gatewayip}:" \ | |
118 | "${netmask}:${hostname}:${netdev}:off\0" \ | |
119 | "addmisc=" \ | |
120 | "setenv bootargs ${bootargs} ${miscargs}\0" \ | |
121 | "addmtd=" \ | |
122 | "setenv mtdparts \"${mtdparts_0};${mtdparts_1}\" ; " \ | |
123 | "setenv bootargs ${bootargs} mtdparts=${mtdparts}\0" \ | |
124 | "addargs=run addcons addmtd addmisc\0" \ | |
125 | "ubiload=" \ | |
126 | "ubi part ${ubimtd} ; ubifsmount ${ubipart} ; " \ | |
127 | "ubifsload ${kernel_addr_r} /boot/${bootfile}\0" \ | |
128 | "netload=" \ | |
129 | "tftp ${kernel_addr_r} ${hostname}/${bootfile}\0" \ | |
130 | "miscargs=nohlt panic=1\0" \ | |
131 | "ubiargs=" \ | |
132 | "setenv bootargs ubi.mtd=${ubimtdnr} " \ | |
133 | "root=${ubipart} rootfstype=ubifs\0" \ | |
134 | "nfsargs=" \ | |
135 | "setenv bootargs root=/dev/nfs rw " \ | |
136 | "nfsroot=${serverip}:${rootpath},v3,tcp\0" \ | |
137 | "ubi_sfsel=" \ | |
138 | "if test \"${boottype}\" = \"rcvr\" ; then " \ | |
139 | "setenv ubisfcs 0 ; " \ | |
140 | "setenv ubimtd rcvrfs ; " \ | |
141 | "setenv ubimtdnr 5 ; " \ | |
142 | "setenv mtdparts mtdparts=${mtdparts_0} ; " \ | |
143 | "setenv mtdids nor0=ff705000.spi.0 ; " \ | |
144 | "setenv ubipart ubi0:rootfs ; " \ | |
145 | "else " \ | |
146 | "setenv ubisfcs 1 ; " \ | |
147 | "setenv ubimtd rootfs ; " \ | |
148 | "setenv ubimtdnr 6 ; " \ | |
149 | "setenv mtdparts mtdparts=${mtdparts_1} ; " \ | |
150 | "setenv mtdids nor0=ff705000.spi.1 ; " \ | |
151 | "setenv ubipart ubi0:rootfs ; " \ | |
152 | "fi ; " \ | |
153 | "sf probe 0:${ubisfcs}\0" \ | |
154 | "ubi_ubi=" \ | |
155 | "run ubi_sfsel ubiload ubiargs addargs ; " \ | |
156 | "bootm ${kernel_addr_r}\0" \ | |
157 | "ubi_nfs=" \ | |
158 | "run ubiload nfsargs addip addargs ; " \ | |
159 | "bootm ${kernel_addr_r}\0" \ | |
160 | "net_ubi=" \ | |
161 | "run netload ubiargs addargs ; " \ | |
162 | "bootm ${kernel_addr_r}\0" \ | |
163 | "net_nfs=" \ | |
164 | "run netload nfsargs addip addargs ; " \ | |
165 | "bootm ${kernel_addr_r}\0" \ | |
166 | "selboot=" /* Select from where to boot. */ \ | |
167 | "if test \"${bootmode}\" = \"qspi\" ; then " \ | |
168 | "led all off ; " \ | |
169 | "if test \"${boottype}\" = \"rcvr\" ; then " \ | |
170 | "echo \"Booting recovery system\" ; " \ | |
171 | "led 3 on ; " /* Bottom RED */ \ | |
172 | "fi ; " \ | |
173 | "led 1 on ; " /* Top RED */ \ | |
174 | "run ubi_ubi ; " \ | |
175 | "else echo \"Unsupported boot mode: \"${bootmode} ; " \ | |
176 | "fi\0" \ | |
177 | ||
569a191a | 178 | #define CONFIG_CMD_UBIFS |
569a191a MV |
179 | #define CONFIG_RBTREE |
180 | #define CONFIG_LZO | |
181 | #define MTDPARTS_DEFAULT \ | |
182 | "mtdparts=ff705000.spi.0:" \ | |
183 | "1m(u-boot)," \ | |
184 | "64k(env1)," \ | |
185 | "64k(env2)," \ | |
186 | "256k(samtec1)," \ | |
187 | "256k(samtec2)," \ | |
188 | "-(rcvrfs);" /* Recovery */ \ | |
189 | ||
190 | #define CONFIG_ENV_IS_IN_SPI_FLASH | |
191 | #define CONFIG_SYS_REDUNDAND_ENVIRONMENT | |
192 | #define CONFIG_ENV_SIZE_REDUND CONFIG_ENV_SIZE | |
193 | #define CONFIG_ENV_SECT_SIZE (64 * 1024) | |
194 | #define CONFIG_ENV_OFFSET 0x100000 | |
195 | #define CONFIG_ENV_OFFSET_REDUND \ | |
196 | (CONFIG_ENV_OFFSET + CONFIG_ENV_SECT_SIZE) | |
197 | ||
198 | #define CONFIG_MISC_INIT_R | |
569a191a | 199 | |
569a191a MV |
200 | /* Support changing the prompt string */ |
201 | #define CONFIG_CMDLINE_PS_SUPPORT | |
202 | ||
203 | /* The rest of the configuration is shared */ | |
204 | #include <configs/socfpga_common.h> | |
205 | ||
206 | #endif /* __CONFIG_SAMTEC_VINING_FPGA_H__ */ |