libc.7: Add a note on why glibc 2.x uses the soname libc.so.6

[thirdparty/man-pages.git] / man4 / hpsa.4

diff --git a/man4/hpsa.4 b/man4/hpsa.4
index c36f5ca0aa87a043df8f6c7e06be7feeb59b0b49..5405b0d69f532f256ff9cb673c32260fcd4d522d 100644 (file)
--- a/man4/hpsa.4
+++ b/man4/hpsa.4
@@ -1,8 +1,9 @@
 .\" Copyright (C) 2011, Hewlett-Packard Development Company, L.P.
 .\" Written by Stephen M. Cameron <scameron@beardog.cce.hp.com>
+.\"
 .\" %%%LICENSE_START(GPLv2_ONELINE)
 .\" Licensed under GNU General Public License version 2 (GPLv2)
-.\" %%%END_LICENSE
+.\" %%%LICENSE_END
 .\"
 .\" shorthand for double quote that works everywhere.
 .ds q \N'34'
@@ -69,7 +70,7 @@ and
 the RAID controller via the SCSI generic driver
 .RB ( sg (4)),
 with device nodes named
-.IR /dev/sd*,
+.IR /dev/sd* ,
 .IR /dev/st* ,
 and
 .IR /dev/sg* ,
@@ -79,7 +80,7 @@ respectively.
 .I /sys/class/scsi_host/host*/rescan
 This is a write-only attribute.
 Writing to this attribute will cause the driver to scan for
-new, changed, or removed devices (e.g,. hot-plugged tape drives,
+new, changed, or removed devices (e.g., hot-plugged tape drives,
 or newly configured or deleted logical drives, etc.)
 and notify the SCSI midlayer of any changes detected.
 Normally a rescan is triggered automatically
@@ -88,7 +89,7 @@ command-line variety);
 thus, for logical drive changes, the user should not
 normally have to use this attribute.
 This attribute may be useful when hot plugging devices like tape drives,
-or entire storage boxes containing pre-configured logical drives.
+or entire storage boxes containing preconfigured logical drives.
 .TP
 .I /sys/class/scsi_host/host*/firmware_revision
 This attribute contains the firmware version of the Smart Array.
@@ -128,7 +129,7 @@ For example:
 This attribute contains the 16 hex-digit (8 byte) LUN ID
 by which a logical drive or physical device can be addressed.
 .IR c : b : t : l
-are the controller, bus, target and lun of the device.
+are the controller, bus, target, and lun of the device.
 .nf
 
 For example:
@@ -168,7 +169,7 @@ Returns driver version in three bytes encoded as:
 .BR CCISS_PASSTHRU ", " CCISS_BIG_PASSTHRU
 Allows "BMIC" and "CISS" commands to be passed through to the Smart Array.
 These are used extensively by the HP Array Configuration Utility,
-SNMP storage agents, etc.
+SNMP storage agents, and so on.
 See
 .I cciss_vol_status
 at