]>
Commit | Line | Data |
---|---|---|
f4b7532f JT |
1 | How to use U-Boot on Engicam i.CoreM6 DualLite/Solo and Quad/Dual Starter Kit: |
2 | ----------------------------------------------------------------------------- | |
3 | ||
4 | - Build U-Boot for Engicam i.CoreM6 QDL: | |
5 | ||
6 | $ make mrproper | |
7 | $ make icorem6qdl_mmc_defconfig | |
8 | $ make | |
9 | ||
10 | This will generate the SPL image called SPL and the u-boot.img. | |
11 | ||
12 | - Flash the SPL image into the micro SD card: | |
13 | ||
14 | sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync | |
15 | ||
16 | - Flash the u-boot.img image into the micro SD card: | |
17 | ||
18 | sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync | |
19 | ||
20 | - Jumper settings: | |
21 | ||
22 | MMC Boot: JM3 Closed | |
23 | ||
24 | - Connect the Serial cable between the Starter Kit and the PC for the console. | |
25 | (J28 is the Linux Serial console connector) | |
26 | ||
27 | - Insert the micro SD card in the board, power it up and U-Boot messages should | |
28 | come up. | |
29 | ||
30 | - Note: For loading Linux on Quad/Dual modules set the dtb as | |
31 | icorem6qdl> setenv fdt_file imx6q-icore.dtb |