board/freescale/mx6ul_14x14_evk/README

   1 How to use U-Boot on Freescale MX6UL 14x14 EVK
   2 -----------------------------------------------
   3
   4 - Build U-Boot for MX6UL 14x14 EVK:
   5
   6 $ make mrproper
   7 $ make mx6ul_14x14_evk_defconfig
   8 $ make
   9
  10 This will generate the SPL image called SPL and the u-boot.img.
  11
  12 - Flash the SPL image into the micro SD card:
  13
  14 sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
  15
  16 - Flash the u-boot.img image into the micro SD card:
  17
  18 sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync
  19
  20 - Jumper settings:
  21
  22 SW601: 0 0 1 0
  23 Sw602: 1 0
  24
  25 where 0 means bottom position and 1 means top position (from the
  26 switch label numbers reference).
  27
  28 - Connect the USB cable between the EVK and the PC for the console.
  29 (The USB console connector is the one close the push buttons)
  30
  31 - Insert the micro SD card in the board, power it up and U-Boot messages should
  32 come up.