doc/README.SBC8560

   1 The port was tested on Wind River System Sbc8560 board
   2 <www.windriver.com>. U-Boot was installed on the flash memory of the
   3 CPU card (no the SODIMM).
   4
   5 NOTE: Please configure uboot compile to the proper PCI frequency and
   6 setup the appropriate DIP switch settings.
   7
   8 SBC8560 board:
   9
  10 Make sure boards switches are set to their appropriate conditions.
  11 Refer to the Engineering Reference Guide ERG-00300-002. Of particular
  12 importance are: 1) the settings for JP4 (JP4 1-3 and 2-4), which
  13 select the on-board FLASH device (Intel 28F128Jx); 2) The settings
  14 for the Clock SW9 (33 MHz or 66 MHz).
  15
  16         Note:   SW9 Settings: 66 MHz
  17                 4:1 ratio CCB clocks:SYSCLK
  18                 3:1 ration e500 Core:CCB
  19                 pos1 - on, pos2 - on, pos3 - off, pos4 - on, pos5 - off, pos6 - on
  20         Note:   SW9 Settings: 33 MHz
  21                 8:1 ratio CCB clocks:SYSCLK
  22                 3:1 ration e500 Core:CCB
  23                 pos1 - on, pos2 - on, pos3 - on, pos4 - off, pos5 - off, pos6 - on
  24
  25
  26 Flashing the FLASH device with the "Wind River ICE":
  27
  28 1) Properly connect and configure the Wind River ICE to the target
  29    JTAG port. This includes running the SBC8560 register script. Make
  30    sure target memory can be read and written.
  31
  32 2) Build the u-boot image:
  33         make distclean
  34         make SBC8560_66_config or SBC8560_33_config
  35         make CROSS_COMPILE=.../ELDK3.0/ppc_8xx-/ all
  36
  37    Note: reference is made to the ELDK3.0 compiler. Further, it seems
  38          the ppc_8xx compiler is required for the 85xx (no 85xx
  39          designated compiler in ELDK3.0)
  40
  41 3) Convert the uboot (.elf) file to a uboot.bin file (using
  42    visionClick converter). The bin file should be converted from
  43    fffc0000 to ffffffff
  44
  45 4) Setup the Flash Utility (tools menu) for:
  46
  47    Do a "dc clr" [visionClick] to load the default register settings
  48    Determine the clock speed of the PCI bus and set SW9 accordingly
  49         Note: the speed of the PCI bus defaults to the slowest PCI card
  50    PlayBack the "default" register file for the SBC8560
  51    Select the uboot.bin file with zero bias
  52    Select the initialize Target prior to programming
  53    Select the V28F640Jx (8192 x 8) 1 device FLASH Algorithm
  54    Select the erase base address from FFFC0000 to FFFFFFFF
  55    Select the start address from 0 with size of 4000
  56
  57 5) Erase and Program